Cisco Systems OL-31386-01 specifications Unpacking, Configurations, External Antennas

Page 6

4Unpacking

To unpack the access point, follow these steps:

Step 1 Unpack and remove the access point and the accessory kit from the shipping box.

Step 2 Return any packing material to the shipping container and save it for future use.

Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco representative or reseller for instructions.

–The access point

–Mounting bracket (only if selected when you ordered the access point)

–Adjustable ceiling-rail clip (only if selected when you ordered the access point)

5Configurations

The 2700 series access point contains two simultaneous dual-band radios, the 2.4-GHz MIMO radio and the 5-GHz 802.11ac MIMO radio.

The 2700 series access point’s configurations are:

•AIR-CAP2702E-x-K9, AIR-AP2702E-UXK9—two 2.4-GHz/5-GHz dual-band radios, up to 4 external dual-band dipole antennas

•AIR-CAP2702I-x-K9, AIR-AP2702I-UXK9—two 2.4-GHz/5-GHz dual-band radios, with integrated dual-band antennas

For information on the regulatory domains, see “Regulatory Domains” section on page 7.

External Antennas

The 2702E model is configured with up to four external dual-band dipole antennas, and two 2.4-GHz/ 5-GHz dual-band radios. The radio and antennas support frequency bands 2400–2500 MHz and 5180–5865 MHz through a common dual-band RF interface. Features of the external dual-band dipole antennas are:

•Four RTNC antenna connectors on the top of the access point

•Four TX/RX antennas

These antennas are supported on the 2702E:

•AIR-ANT2524DB-R

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Cisco Aironet 2700 Series Access Points OL-31386-01 Last Updated March 31 Introduction to the Access Point About this GuideSafety Instructions Important Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Internal Antennas Regulatory DomainsAccess Point Ports and Connectors Access Point Ports and Connections top-2702E ModelAccess Point LED Indicator top-2702I Model 352657 Configuring the Access Point Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsPage Mounting the Access Point Deploying the Access Point on the Wireless NetworkTroubleshooting Guidelines for Using Cisco Aironet Lightweight Access PointsUsing Dhcp Option Checking the Access Point LEDLED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information For Home or Office USEPage Vcci Statement for Japan 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry Canada Canadian Compliance StatementFrench Translation Access Point Models Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Declaration of Conformity Statements Portuguese TranslationConfiguring Dhcp Option 43 and Dhcp Option Access Point Specifications Add the option 60 line using the following syntax
Top Page Image Contents