Unitron Hearing Aid UMIC manual There is too much noise, I cannot understand the speaker

Page 16

Most probable cause Remedy

There is too much noise, I cannot understand the speaker

Most probable cause Remedy

uMic is no longer recognized by the uDirect 2 with which it was previously paired

Your hearing aid	Reduce the hearing aid
microphones are set	volume by pressing the
too loud	uDirect 2 ( ) key until you
	reach a comfortable level.
	Place the uMic closer to the

2 minutes after no device was found, uDirect 2 stops seeking devices to save power

Switch uDirect 2 off. Wait until the red power indicator turns off, then turn device on again

	speakers mouth (20 cm, 8’’).
	Use the uMic ( ) button to
	increase the uMic volume
The uMic rubs against	Make sure the uMic is clipped
the wearer’s clothing	firmly. Clothing should not
	cover the uMic
The settings of your	Please ask your hearing
hearing aids are not right	healthcare professional to
	fine tune your hearing aids

The devices are too far	Bring devices within 1 meter
away from each other	range and try again
uMic can be paired to a	Repeat the pairing between
maximum of 4 different	the devices
Bluetooth devices
(uDirect 2 can be paired
to 8). If the internal
memory is full, the fifth
pairing will delete the
first pairing
Pairing was never done,	Repeat the pairing between
or it was manually	the devices
deleted
The light indicator does not turn solid blue
uMic and uDirect 2 are	Repeat the pairing between
not paired	the devices

26

27

Image 16

Contents Unitron uMic guide Your uMic Thank youThank you for choosing the Unitron uMic Table of contents Quick referenceYour uMic at a glance Retaining clipCharging the uMic Getting startedUDirect 2 into Turning the uMic on and off Put uDirect 2 into pairing mode Switch on the uDirect Pairing the uMic with uDirectPut uMic into pairing mode Understanding the status light Information during operation Information about power and batteryUMic UDirect Connecting the uMic and uDirect Preparing the uDirectSetting the uMic volume Functional test of uMicWearing the uMic correctly UMic pause and resumeSwitch the uMic off when not in use Switching the uMic offSpecial use cases Dedicated uTV UMic and watching TVCharger plugged in while Support of multiple uMics Use of the lanyardTroubleshooting guide Short press the uDirect 2 access button to resume streamingThere is too much noise, I cannot understand the speaker Chargers 5VDC, min mA Providing enough By Unitron Charging currentImportant information Other important information Compliance informationDeclaration of Conformity Information and explanation of symbols Reorient or relocate the receiving antennaOperating conditions Transport and storage conditions0678 Distributor