Omega manual Installation, Mounting the TX91

Page 15

3Installation

3.1Mounting the TX91

The TX91 Transmitter may be:

1.surface mounted,

2.mounted inside a protection head (refer to figure 3-1), or

3.installed into the OMEGA mounting track (part number RT) using an OMEGA mounting bracket (part number TX90-BR).

Figure 3-2 shows the RT mounting track.

Figure 3-3 shows the TX90-BR mounting bracket.

Figure 3-4 shows a typical installation of two transmitters using the 10 mounting bracket and mounting track.

Image 15

Contents User’sGuide Servicing North America Return Requests / Inquiries Introduction Calibration Instructions General Description IntroductionIntroduction TX91 Thermocouple Transmitter Introduction Introduction Straight line Approximation of Curve Models Available FeaturesTX91 Models Available Model Number Description Unpacking Mounting the TX91 InstallationAssembly of the TX91 Transmitter Inside RT Mounting Track in inches TX90-BR Mounting Bracket in inches Mounting Track RT Bracket TX90-BR Wiring the TX91 Refer to Figure Wiring Diagram for the TX91 Potentiometers Equipment Required Calibration InstructionsSet-up of Equipment Calibration Procedures Refer to Figure Calibration Instructions Calibration Set-Up Calibration Set-Up. Alternate Calibration Values for the TX92 Current rating on the power supply Troubleshooting GuideTroubleshooting Guide Model No Description AccessoriesGeneral SpecificationsInput Intrinsically Safe Interconnection Diagram WARRANTY/DISCLAIMER Shop online at omega.com