3M 711/811 owner manual 812FSH006

Page 12

7Install the roll of tags on the supply role shaft and thread the tags through the unit to the take-up spool.

8Remove the take-up spool endplate and the take-up spool.

9If there is a liner from the previous roll of tags, remove it and put the take-up spool back in place.

10Connect the tag roll to the take-up spool and reinstall the end plate.

The figure shows you how the tag installation should look when you are done with the procedure.

On

Off

Jog

812_FSH_006

812_FSH_007

On

Off

Jog

812_FSH_008

812_FSH_002

10

Image 12

Contents Conversion Station Model 711/811 Page Table of Contents Safety Information Intended useImportant Notes Safety Label Locations JapanSpecifications Operating and Storage TemperatureComponents DescriptionUsing the Tag Dispenser Automatic Tag Dispenser componentsOperator tool kit Tool KitLoading the tag dispenser with tags Tag Dispenser Supply Roll Shaft812FSH006 Cleaning the tag dispenser opening Cleaning the spring plate tensioner/guideTroubleshooting Tag Dispenser problems Problem SolutionService 3M Service phone numbersTo order tags