3.Designate a work area that is
PLATFORM | FIGURE B |
(13) |
|
ADJUSTABLE FEET
(11)
FIGURE C
LEVEL INDICATOR
(14)
4.The four Adjustable Feet (11) and Level Indicator (14) of the Scale are used for leveling the unit. Use the Adjustable Feet and Level Indicator to level the Scale accordingly.
(See Figures B and C.)
5.Make sure the sides of the Scale’s Platform (13) do not come in contact with any object prior to setting an object on the Platform to be weighed.
(See Figure B.)
6.Route the Power Cord (17) along a safe route to reach the work area without creating a tripping hazard or exposing the Cord to possible dam- age.
General Operating Instructions
FIGURE D
POWER SWITCH (15)
“I” = ON
“O” = OFF
VIEW FROM REAR OF DISPLAY
1.Plug the Power Cord/Plug (17) into the nearest 110 volt, grounded, electrical outlet. Then turn the Power Switch to its “ON” position. IMPORTANT: Make sure there is no load on the Scale when turning the Power Switch on. (See Figure D.)
2.For best accuracy, allow the Scale to warm up for ten minutes before ap- plying weight.
3.When turned on, the Scale will self- check the rechargeable Battery (16) and display “dc x.xxx”. If necessary, the Scale will automatically enter the Battery into a charging mode.
•When using the Battery (16) to pow- er the Scale, and the Battery volt- age is lower than 5.4V, the Scale will turn off automatically. In this event, plug the Power Cord/Plug into the nearest 110 volt, grounded, electrical outlet and allow the Bat- tery to charge for at least 8 hours for full capacity.
4.After the
SKU 98982 | For technical questions, please call | Page 8 |