•Displaying “HHHHHH” and emitting an alarm sound, meaning the zero position is too high.
•Displaying “LLLLLL” and emitting an alarm sound, meaning the zero position is too low.
Should either of the above events occur, make sure to check for proper line voltage and Battery voltage. Check that the Scale is level, it has no load, and that its Platform (13) is not touching any other object(s).
FIGURE E
Zero/Tare
1.Press the “ZERO/TARE” button the scale is empty (< 4% F.S.1) and the scale will read zero at the current weight. The zero indicator will also show. (See Figure E.)
2.Press “ZERO/TARE” when the weight is positive (> 4% F.S.) and the tare in- dicator will show. The scale will then read based on the tare weight.
3.Remove all weight and press the “ZERO/TARE” button again to exit tare mode.
1Full Scale. The full capacity of the scale. For this item, 330 lb. (150 kg).
Unit:
Press “UNIT” to choose the unit: Lb. or Kg. (See Figure E.)
Hold:
1.Press “HOLD” at any time when weighing. The displayed value will be locked and will not change with weight. Meanwhile, the “HOLD” indi- cator will show. (See Figure E)
2.Press “HOLD” again to exit the hold mode.
Note: Under the hold mode, the Scale will sound an alarm when overloaded al- though the displayed value does not change.
Memory Functions:
1.With a stable weight on the scale, press “ADD“ to add the displayed weight to the unit’s memory. (See Figure E.) The M+ indicator will show and the display will flash
{ADD=__} with the __ being the num- ber of weights in memory and then read the total accumulated weight from memory.
Note: The unit will beep twice if the value is not added (for example if the weight does not remain constant enough.)
2.Press “C” and the cumulative total will be cleared.
Settings
1.To adjust the backlight brightness, press “FUNC“ once and {BAC=0_} will be displayed. The blank is the brightness of the display backlight.
SKU 98982 | For technical questions, please call | Page 9 |