INSTALLATION
1
DISCONNECT THE POWER TO THE PRESS BEFORE BEGINNING INSTALLATION.
Remove the two large side covers over the main framework of the press (one at OPS and one at NOPS) and the NOPS cover at the delivery end of the press.
For an easier installation, you may also want to remove the two guards on the delivery end of the press.
2
3
NOTE: Do not cut the hose if the press is equipped with an Airtech sprayer.
Cut the sprayer hose about halfway between the hopper and the spray bar. A new hose will be attached to the spray mechanism.
NOTE: Do not remove the spray bar if the press is equipped with an Airtech sprayer.
Remove the spray bar by removing the two bolts holding the bracket (subject arrow). Also remove the clip holding the spray hose (subject arrow, picture on following page).
7