Before use
This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this water- tight shaver in the shower and clean it in water.Treat yourself to wet lather shaves for at least three weeks and notice the difference.Your Panasonic Wet/Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.
Charge the shaver for at least 8 hours before using it for the first time or when it has not been in use for more than 6 months.
Parts identification
(see fig. 1)
AProtective cap
BSystem outer foil
CInner blades
DSystem outer foil release but- tons
EPivot action selector
F Battery capacity monitor/
Charging status lamp
GOn/Off switch
HTrimmer
ITrimmer handle
JCharging adaptor holder
KCharging adaptor with auto- matic voltage adjustment
LRotatable stand
Charging adaptor
(see fig. 1)
Lift up the charging adaptor holder when charging the shaver. (See fig. 1(A))
(Restore the charging adaptor holder when carrying the unit.) (See fig. 1(B))
When using the charging adaptor, rotate the stand at the base of the charging adaptor to ensure that it is stable. (See fig. 1(C))
Charging
(see fig. 2)
Place the charging adaptor upright on a flat surface. Plug the adaptor into an AC outlet.
It will adjust automatically to voltages between
In some areas, a special plug adap- tor may be required.
Switch the shaver off and place it up- right into the charging adaptor with the switch facing toward the front.
The charge status lamp will glow when the shaver is placed on the correct position. It will flash when the charging is completed.
At the same time, the battery capac- ity monitor will display the fully charged condition (see fig. 2 (A)).The battery capacity monitor will turn off in about 10 minutes after the charg- ing has been completed (see fig. 2 (B)).
You can fully charge the shaver in 1 hour if the battery capacity monitor flashes down to the 20% level.
A full charge will supply enough power for about 14 shaves (3 min-
7
7