2.Remove the screw (a) and the panel cover (b).
3.Remove the two screw covers (c) (using something like a tooth- pick), and 6 screws (d).
4.Remove the back panel (e).
5.Lift the battery block (f) and re- move it from the battery terminal sealing (g).
6.Remove the batteries from the battery block (h).
WARNING:
Do not attempt to replace the bat- teries for the purpose of reusing the shaver. This could result in the risk of fire or electric shock.
Caution
•Do not charge the shaver where the temperature is below 0°C (32°F) or above 40°C (104°F), where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture.
•Use only the included shaver charging adaptor
•The supply cord of the charging adaptor cannot be replaced; if the cord is damaged, the entire charger should be discarded.
•Dry the shaver completely before setting it in the charging adaptor.
•Keep the charging adaptor away from water and handle it only with dry hands. Do not use an extension cord to connect the charging adap- tor to an outlet.
•The shaver may not immediately begin to charge after being placed into the charging adaptor after use. Allow the shaver to sit in the charg- ing adaptor for a few minutes and check again to make sure that it is being charged.
•Do not place any metal objects like coins and paper clips on the charg- ing adaptor as they will become warm.
•Grip the plug when disconnecting the charging adaptor from a recep- tacle; tugging on the cord may dam- age it.
•Store the charging adaptor and its cord set in a dry area where it will be protected from damage.
•The linear motor of the shaver may start operating without the On/Off switch on if the shaver is placed near a television, stereo, audio- visual equipment or anything that generates strong magnetic field.
Do not place the shaver near these equipments.
•The outer foil is very thin. If han- dled improperly, it can be easily damaged. To avoid personal injury, do not use the shaver if it has a damaged foil or inner blade.
•Wash the shaver in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for toilets, bath- rooms or kitchen appliances. Do not submerge the shaver for a long time.
•Do not wipe any part of the shaver
with thinner, benzine or alcohol. Clean it by using a cloth dampened
10with soapy water.
•Do not take the housing apart as this can affect the watertight con- struction.
•Do not shave when the “sonic” vi- bration is activated, as it may dam- age your skin.
Specifications
Power source:
Motor voltage: 2.4 V DC
Charging time: 1 hour
This product is intended for house- hold use only.
READ ALL INSTRUCTIONS BE-
FORE USE.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED ON THE BACK PAGE.
11
11