Before use, Parts identification, Charging

		e
		b
	f	c
	f	a
		a

Before use

This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this water- tight shaver in the shower and clean it in water. The following is the sym- bol of Wet shaver.The symbol means that hand-held part may be used in a bath or shower.

JLow battery indicator

KOn/Off switch

LTrimmer

MTrimmer handle

NAdaptor

OPower cord

READ ALL INSTRUCTIONS BE- FORE USE.

Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/ Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.

Parts identification

(see fig. 1)

AProtective cap

BSystem outer foil

CSystem outer foil release but- tons

DFoil frame

EInner blades

FFoil frame release buttons

GLED display

HBattery capacity monitor

H-a high

H-b mid

H-c low

ICharge status lamp

Charging

When charging the shaver for the first time or when it has not been in use for more than 6 months, charge it for at least 8 hours before use.

Connect the power cord to the shaver, and plug the adaptor into an AC outlet.

In some areas, a special plug adap- tor may be required.

[for ES7037]

The charge status lamp will glow when the shaver is being charged. The battery capacity monitor will fully illuminate and the charge status lamp will blink after charging is completed (see fig. 2 (A)).

10 minutes after charging is com- pleted, the battery capacity monitor will turn off and the charge status lamp will continue to blink (see fig. 2 (B)).

You can fully charge the shaver in 1 hour if the LED display shows “low”. The battery capacity monitor indi- cates the charge remaining in the battery in 3 levels “high/mid/low” (high/mid/low). The unit can be used once or twice more after “low” starts