Setting remote control signals for home theatre systems
Selecting and entering device codes
You can have all remote control signals for a home theatre system device learnt all at once by entering the device code for that device.
Note:
For device codes which have a remote control signal for controlling the power supply, the remote control signal for the power supply will be transmitted when the device code is selected. Turn on the power supply for the device to be operated, and point the remote control towards it to test. Two or more equipment codes cannot be entered for the same device.
Device codes cannot be entered for “PJ”.
If the home theatre system device does not support this function, it will not operate when the buttons are pressed.
1Press "SETUP" for 3 seconds or more.
When “USER
2Select the device to be set and then
2Select the device to be set and then press "ENTER".
When “DVD, VCR, AMP” is select
Continue to step 3
When “TV/TNR” is selected
2Select the device to be set and then -1 press.
ＴＶ 
ＳＡＴ
ＣＢＬ
Continue to step 3
ＤＶＤ |
| ＳＣＲＥＥＮ |
| ＬＩＧＨＴＩＮＧ |
| ＲＣＶ |
ＡＭＰ
ＶＣＲ
ＴＶ 
ＣＢＬ
ＳＡＴ
3 | Select the desired device code while |
|
|
| |
| referring to the device code list ( | p.4) |
and then press "ENTER".
If the operation does not work
Refer to the device code list, and if more than one device code is given, try setting using the other device codes.
When “USER 1-3” is selected
Press "SETUP" to finish.
Note:
Device codes can be selected even if the learning function has already been used to program the remote control signals, but in such cases, the remote control signals that have been learnt will have priority. If you would like to set a device code for these buttons, delete the remote control
signals which have already been learnt. (
p. 9)
If operation macros have already been assigned to function buttons the operation macros will have priority. If you would like to set a device code for these buttons, delete the operation macros which have already been assigned.
( 
p. 11)
ENGLISH - 7
