Names and functions of each part
Buttons shown in this colour are buttons that can be used for learnt functions.
Buttons that cannot be used for learnt functions LEARN, SETUP, system device selection
Buttons that cannot be used for learnt functions when using a projector (PJ) MENU, ENTER, RETURN,
If you press any of the buttons marked as Projector function only , the device selection will switch to "PJ".
(※"PJ" 
p.15)
Remote control emitter
Projector function only
This turns the projector power on and off when the projector's power is turned on
Liquid crystal display
The top shows the selected device, the bottom shows the functions of that device
that can be operated. (※
p.15)
If no remote control operations are carried out for 30 seconds or more, the LCD will switch off. If the LCD switches off while the device selection indicator for any component is flashing, the component that was last selected will be the one that will be operated.
Function buttons(A/B/C)
This displays menus
Projector function only
This returns menu adjustment values to their factory defaults.
This adjusts the picture size and focus.
This switches the input source.
This switches the aspect ratio (the ratio between width and height of the screen).
This switches the picture mode.
This displays the input waveforms.
This turns on button illumination for the remote control.
If no remote control operations are carried out for 30 seconds or more, the backlight will switch off.
Once the backlight has turned off after 30 seconds, it can be turned back on by pressing any button.
If you press a button to turn once more and then press it again within 30 seconds to turn the backlight off again, the backlight will not turn back on again when another button (other than "LIGHT") is pressed.
System device operation buttons
These buttons are used to operate system devices using preset functions for this remote control and also functions which have been learnt through signals from other remote controls.
These buttons are used for menu screen operations.
Projector function only
This momentarily pauses images.
This sets the time to elapse before the power turns off automatically.
This displays the "MEMORY
LOAD" menu.
This displays the "COLOUR
MANAGEMENT" menu.
This displays the "PICTURE
ADJUSTMENT" menu.
Note:
If operating the remote control by facing it directly towards the remote control receiver at the front of the projector, the remote control should be within approximately 7 metres of the front of the remote control receiver. In addition, the remote control can be operated within an angle of +/- 30 degrees up, down or to the left or right.
If there are any obstructions between the remote control and the remote control receiver, the remote control may not operate correctly.
The projector can be operated by reflecting the signals from the remote control off the screen, but the operating range for the remote control may be reduced as a result of losses in the amount of light reflected due to the characteristics of the screen.
2 - ENGLISH
