Turning the power for home theatre system devices on and off at once (power supply macro function)
You can use the projector's remote control to turn the power on and off for home theatre system devices that have been registered by the remote control.
Note:
At the time of purchase, a macro for turning the power on and off for PJ, DVD, VCR and AMP all at once is set.
Using the power supply macro function
Note:
If the distance that the projector's remote control has to operate is too far, or if the remove control receiver of the home theatre system devices are obstructed, this operation may not work correctly.
Check the locations and directions of the home theatre system devices to make sure that they can all be operated.
1Press "SYSTEM" for 3 seconds or more.
The power supply for all registered devices will turn on.
The length of time required for the macro function to finish operating effectively will vary depending on the number of devices that have been registered.
Configuration de la fonction macro d'alimentation
1Press "SETUP" for 3 seconds or more.
2Use the tilt button to select "PJ", and then press "ENTER".
3Press "ENTER", 2 times.
The display will show the
devices hat have been registered by the macro.
4Use the tilt button to select the device to be registered.
If a registered device is selected, the display will flash faster.
5Press "SYSTEM".
(Example: When "USER3" is selected)
If a registered device is selected, the display will flash faster.
To register or delete another device, repeat steps 4 and 5. Clearing the macro function.
Clearing the macro function
Press "SYSTEM" once more.
The macro function will be cleared and the display will flash more slowly.
6When you have finished selecting devices, press "ENTER".
To finish, press "SETUP". 
12 - ENGLISH
