Braun NUVL855RM24 service manual Inner Roll Stop Adjustment, Figure a

CAUTION

Do not adjust inner roll stop linkage rod. Linkage rod adjust- ment may result in lift damage.

Floor Level and Inner Roll Stop Adjustments

Inner Roll Stop Adjustment

Do not adjust inner roll stop linkage rod at this time! Link- age rod adjust-

ment is not required unless extra usable platform length is needed. If the

angle of the inner roll stop (when in the vertical position) restricts the usable platform length for the wheelchair passenger, adjustment of the linkage rod will change the angle.

With the platform at ground level and the inner roll stop in the vertical position, there should be a minimum of 1" clearance between the in- ner roll stop and torque tube. See Photo I.

Adjust the inner roll stop as detailed in the fol- lowing procedures. Then, adjust the linkage rod as detailed on page 10 (only if necessary).

1.Raise the lift platform fully (floor level) using the manual operation system (Manual Op- erating Instructions detailed on Quick Refer- ence Installation Sheet). If the inner roll stop rests properly on the floor, do not adjust the inner roll stop. Lower the platform to ground level. If the angle of the inner roll stop (when in the vertical position), does not restrict the usable platform length for the wheelchair passenger, disregard inner roll stop adjust- ment procedures. See Photo G on page 10. Refer to the following procedures if adjust- ment is required.

2.Position the lift platform ap- proximately 12" above stow level using the manual operation system. See Photo C.

Raising the platform will allow access to the cam securement screw and nut. See Photo E.

Inner Roll Stop

B

Linkage Rod

Manual Operation Systems

T-Handle	VALVE	Hand
Release		Pump

Cable	N	C
		L
	E	O
	P	S
	O	E

	Pump
Figure A	Handle	Valve

Stow Level

Platform

12"

above

Stow

Level

C

Page 8