English
Do not put the shaver back into the
Do not connect the shaver to the mains again after you have removed the rechargeable battery.
guarantee and support
If you need information or support, please visit www.philips.com/ support or read the separate worldwide guarantee leaflet.
guarantee restrictions
The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem | Possible cause | Solution |
|
|
|
The shaver does | The Jet Clean System has not | Clean the shaver thoroughly before you |
not shave as well | cleaned the shaver properly because | continue shaving. If necessary, clean and |
as it used to. | the cleaning fluid in the cleaning | refill the cleaning chamber (see chapter |
| chamber is soiled or the cleaning | ‘Cleaning and maintenance’). |
| fluid level is too low. |
|
| The shaving heads are damaged or | Replace the shaving heads (see chapter |
| worn. | ‘Replacing the shaving heads’). |
| Long hairs obstruct the shaving | Clean the shaving heads one by one (see |
| heads. | section ‘Cleaning the shaving unit with the |
|
| cleaning brush’ in chapter ‘Cleaning and |
|
| maintenance’). |
The shaver does not work when I press the on/off button.
You have not inserted the shaving | Make sure that the projections of the |
heads properly. | shaving heads fit exactly into the recesses |
| (see section ‘Cleaning the shaving unit with |
| the cleaning brush’). |
The rechargeable battery is empty. | Recharge the battery (see chapter |
| ‘Charging’) or connect the shaver to the |
| mains. |
The shaver is not entirely clean after I clean it in the Jet Clean System.
The temperature of the shaver is too high. In this case, the shaver does not work.
The cleaning fluid in the cleaning chamber is soiled.
37
As soon as the temperature of the shaver has dropped sufficiently, you can switch on the shaver again.
Empty and rinse the cleaning chamber (see section ‘Cleaning the shaving unit in the Jet Clean System’ in chapter ‘Cleaning and maintenance’).
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PT729CC_A6_CS3.indd 37 |
|
| 13.4.26 2:47:22 PM | ||||||