English
5To remove the shaver from the Jet Clean System, move the locking
lever upwards until it does not go any further and remove the shaver.
Using the shaver
Note:You can also use the appliance directly from the mains. Simply connect the shaver to the mains.
shaving
1 Press the on/off button once to switch on the shaver.
2 Move the shaving heads over your skin. Make circular movements.
- Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system.
3 Press the on/off button once to switch off the shaver.
4 Clean the shaver (see chapter ‘Cleaning and maintenance’).
Cleaning and maintenance
Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the Jet Clean System.
-The best and most hygienic way to clean the shaver is in the Jet Clean System.You can also rinse the shaver under the tap or clean it with the cleaning brush supplied.
-Clean the shaver after every shave for optimal shaving performance.
-Regular cleaning guarantees better shaving performance.
-For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110) and the Jet Clean solution (HQ200).
-Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.
Note:Water may leak from the socket at the bottom of the shaver when you rinse it.This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver.
Cleaning the shaving unit under the tap
1Switch off the shaver and disconnect it from the mains.
29
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PT729CC_A6_CS3.indd 29 |
|
| 13.4.26 2:47:17 PM | ||||||