B
A |
English
Preparing the Jet Clean system for use
Note: Fill the cleaning chamber before first use and when the ‘fluid low’ symbol flashes to indicate that the fluid level is too low.When the fluid level drops below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start to flash and the shaver holder returns to its starting position
1Simultaneously press the release buttons on both sides of the cleaning chamber (A).Then lift the Jet Clean System off the cleaning chamber (B).
,The cleaning chamber remains behind.
2Unscrew the cap from the bottle with Jet Clean solution (HQ200) and remove the airtight seal.
3Fill the cleaning chamber with Jet Clean solution (HQ200) up to the MAX indication.
Note: Make sure the cleaning chamber is always filled above the MIN indication.
4Place the Jet Clean System back onto the cleaning chamber (‘click’). Make sure that the release buttons snap back into place.
When the cleaning chamber is filled with Jet Clean solution, do not move it to prevent leakage.
5Put the small plug in the Jet Clean System and put the adapter in the wall socket.
,The shaver holder automatically moves to its highest position.
The Jet Clean System is now ready for use.
Using the Jet Clean system
1Place the shaver without protection cap upside down in the shaver holder. Push down the locking lever completely to lock the shaver into place.
,The battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged.
Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit.
32
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PT729CC_A6_CS3.indd 32 |
|
| 13.4.26 2:47:19 PM | ||||||