English
-Never immerse the shaver in water.
-Never immerse the Jet Clean System in water nor rinse it under the tap.
-Do not use the shaver in the bath or in the shower.
-Never use water hotter than 80°C to rinse the shaver.
-Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.
-The shaver, the Jet Clean System and the other accessories are not
-Water may leak from the socket at the bottom of the shaver when you rinse it.This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver.
-Do not use the shaver, Jet Clean System, adapter or any other part if it is damaged, as this may cause injury. Always replace a damaged adapter or part with one of the original type.
-Use, charge and store the shaver and the Jet Clean System at a temperature between 10°C and 35°C.
-Always place and use the shaver and the Jet Clean System on a surface that is
-Only use the adapter and accessories supplied.
-Always put the protection cap on the shaver to prevent damage and to avoid dirt accumulation in the shaving heads.
-Only use the Jet Clean System with the original Jet Clean solution (HQ200).
-Always place the Jet Clean System on a stable, level and horizontal surface to prevent leakage.
-When the Jet Clean System is ready for use, do not move it to prevent leakage.
-The Jet Clean System thoroughly cleans but does not disinfect your shaver, therefore do not share the shaver with others.
-Empty the cleaning chamber of the Jet Clean System and clean the cleaning chamber thoroughly by rinsing it with hot tap water every 15 days.
-If the shaver and the Jet Clean System are subjected to a major change in temperature, pressure or humidity, let them acclimatise for 30 minutes before you use them.
Compliance with standards
26
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PT729CC_A6_CS3.indd 26 |
|
| 13.4.26 2:47:16 PM | ||||||