Philips 1045219 manual Immunity Test IEC 60601 Test Compliance Level

20

Guidance and Manufacturer’s Declaration - Electromagnetic Immunity

This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment.

Immunity Test	IEC 60601 Test	Compliance Level	Electromagnetic Environment -
	Level		Guidance
Electrostatic Discharge	±6 kV contact	±6 kV contact	Floors should be wood, concrete
(ESD)	±8 kV air	±8 kV air	or ceramic tile. If floors are covered
IEC 61000-4-2			with synthetic material, the relative
			humidity should be at least 30%.
Electrical Fast Transient/	±2 kV for power supply	±2 kV for supply mains	Mains power quality should be
Burst	lines	±1 kV for input/output	that of a typical home or hospital
IEC 61000-4-4	±1 kV for input-output	lines	environment.
	lines
Surge	±1 kV differential mode	±1 kV differential mode	Mains power quality should be
IEC 61000-4-5	±2 kV common mode	±2 kV for common mode	that of a typical home or hospital
			environment.
Voltage dips, short	<5% UT	<5% UT	Mains power quality should be
interruptions and voltage	(>95% dip in UT) for 0.5	(>95% dip in UT) for 0.5	that of a typical home or hospital
variations on power	cycle	cycle	environment.
supply input lines	40% UT	40% UT
IEC 61000-4-11	(60% dip in UT) for 5	(50% dip in UT) for 5
	cycles	cycles
	70% UT	70% UT
	(30% dip in UT) for 25	(30% dip in UT) for 25
	cycles	cycles
	<5% UT	<5% UT
	(>95% dip in UT) for 5 sec	(>95% dip in UT) for 5 sec
Power frequency (50/60	3 A/m	3 A/m	Power frequency magnetic fields
Hz) magnetic field			should be at levels characteristic of a
IEC 61000-4-8			typical location in a typical hospital
			or home environment.

NOTE: UT is the a.c. mains voltage prior to application of the test level.

BiliTx Parents’ Manual