TE-101.IB.v2 4/7/06 12:18 PM Page 11
MEMORY RECALL
This thermometer will automatically store the last 10 measurements in memory. The most recent reading will automatically display when the unit is turned on. Each new temperature reading will also be entered into the memory as the most recent record.
When in memory mode, an arrow in the upper left corner will appear with the memory record number to the right as shown in the illustration below.
Indicates memory reading and number
Press “MEMORY” to cycle through the records from number 0 (the most recent reading) to number 9.
Note that when memory is at capacity, the oldest record will be deleted to make room for a new reading.
Memory will be cleared as a result of battery removal or power failure. A default reading of 00.0°F (00.0°C) will be displayed when memory is cleared until a new temperature reading is taken.
10
HOW TO TAKE A TEMPERATURE READING
1.Always make sure that the waterproof probe has been cleaned with a cotton swab moistened with alcohol since its previous usage.
2.Press and release the “SCAN” button on the side of the device. All display symbols will appear for approximately one second (Figure 1).
Figure 1
3.When the ear thermometer is ready, the display will next show the results from the last reading. The unit is ready for measurement at this point (Figure 2).
Figure 2
Indicates a memory reading
11