Fluke VT04A, VT02 user manual Power On and Off, Start-Up Screen and Status Indicator

Page 13

Visual IR Thermometer

Power On and Off

Power On and Off

To turn on the Product, push and hold  for 2 seconds. A start-up screen shows on the display and an indicator bar shows the status, see Figure 1. The indicator bar increases on power up and decreases on power down. After the start-up screen, the Product is ready to use. To turn off the Product, push and hold  for 2 seconds.

The LCD backlight (VT04A and VT04) turns off to save battery power if a button is not pushed for more than 2 minutes. You can push any button to turn on the backlight before the auto off time is exceeded. This feature is disabled in Alarm mode.

The Auto Off (VT04A and VT04) feature turns off the Product after a selected time interval. The default setting is 10 minutes and is user-selectable as 5, 10, 15, or 20 minutes of inactivity. This feature is disabled in Alarm mode.

VT02

VT04A, VT04

hak03.eps

Figure 1. Start-Up Screen and Status Indicator

For the first time use, or when the batteries are removed for more than a few hours, the Date and Time menu opens. See page 19 for more information about how to set the date and time.

Note

All visual IR thermometers need sufficient warm-up time for the most accurate temperature measurements. This time can often vary by model and by environmental conditions. Although most visual IR thermometers are fully warmed up in 3 to 5 minutes, it is always best to wait a minimum of 10 minutes if the most accurate temperature measurement is very important to your application. When you move a visual IR thermometer between environments with large differences in ambient temperature, more adjustment time can be required.

5

Image 13
Contents VT02, VT04A, VT04 Limited Warranty and Limitation of Liability Table of Contents VT02, VT04A, VT04 List of Tables VT02, VT04A, VT04 List of Figures VT02, VT04A, VT04 Introduction Safety Information How to Contact FlukeVisual IR Thermometer VT04A Before You StartStart-Up Screen and Status Indicator Power On and OffRechargeable Battery Rechargeable BatteryFeatures and Controls Image Blending Button OperationVisual Image Alignment Visual Image Alignment ControlMicro SD Memory Card Warning Icons Capture and SaveBasic Navigation Menu FunctionsParameter Adjustment Menu Icons Description VT02 Emissivity Review Memory Warning Temperature MeasurementTemperature Measurement Accuracy On-Screen Comparison of DS Ratio Color Palette Reflected Background TemperatureHot and Cold Markers Date and Time Temperature UnitsHigh/Low Temperature Alarm High/Low Temperature Alarm VT04A, VT04To set the time-lapse Time-Lapse Image Capture VT04A, VT04To stop the Auto-Monitor Alarm Auto-Monitor Alarm VT04A, VT04Image Capture Scenarios for Auto-Monitor Alarm Auto Off VT04A, VT04 Factory Reset VT04A, VT04LCD Brightness VT04A, VT04 BMP File Format VT04A, VT04Smartview Software MeasurementsHow to Clean Maintenance  Caution Battery CareVT02, VT04A VT04 SpecificationsImage Presentation Controls and Adjustments Batteries