Invacare RPS350-1 user manual Transferring the Patient

Page 17

SECTION 5—TRANSFERRING THE PATIENT

SECTION 5—TRANSFERRING THE PATIENT

WARNING

DO NOT attempt any transfer of a patient without the approval of the patient’s physician, nurse or medical assistant.

DO NOT move the patient if the sling is not properly connected to the attachment points of the stand up lift. Check that the sling is properly connected to the attachment points prior to lifting a patient. If any attachments are not properly in place, correct the problem. When the sling is elevated a few inches off the stationary surface and before moving the patient, check again to make sure that all sling attachments are secure. If any attachments are not properly in place, lower the patient back onto the stationary surface and correct this problem - otherwise, injury or damage may occur.

Adjustments for safety and comfort should be made before moving the patient.

DO NOT use slings and stand up lifts of different manufacturers. Invacare slings are made specifically for use with Invacare stand up lifts. Otherwise, injury or damage may occur.

Invacare does not recommend locking the rear casters of the stand up lift when lifting and transferring an individual. Doing so could cause the lift to tip and endanger the patient and assistants. Invacare recommends that the rear casters be left unlocked during lifting and transferring procedures to allow the stand up lift to stabilize itself when the patient is initially lifted from and transferred to a chair, bed or any stationary object.

The legs of the stand up lift MUST be in the maximum open position for optimum stability and safety. If the patient is in a sling and it becomes necessary to move through a narrow passage, close the legs of the stand up lift only as long as it takes to move through the passage. When the stand up lift is through the passage, return the legs to the maximum open position. If it is necessary to close the legs to maneuver the stand up lift under a bed, close the legs only as long as it takes to position the stand up lift over the patient and lift the patient off the surface of the bed. When the legs of the stand up lift are no longer under the bed, return the legs to the maximum open position.

Be sure to check the sling attachments each time the sling is removed and replaced to ensure that it is properly attached before the patient is removed from a surface.

The use of one assistant is based on the evaluation of the health care professional for each individual case.

Part No. 1078984

17

Stand Up Patient Lift

Image 17
Contents Stand Up Patient Lift RPS350-1 Symbol Legend Accessories WarningTable of Contents Limited Warranty Special Notes Label Location RPS350-1 Stand Up Patient Lift Product ParametersUsing the Sling Weight LimitationGeneral Guidelines Assembling the LiftOperating the Lift Performing MaintenanceLifting the Patient Transferring the PatientInstall the Shifter Handle AssemblyUnpacking the Patient Lift Assembling the Patient LiftMay occur Attaching the Battery Charger Mounting Bracket to the WallOperation Using the Emergency StopLocking/Unlocking the Rear Casters Raising/Lowering the Patient LiftActivating a Mechanical Emergency Release Charging the BatteryPositioning the Stand Up Lift Lifting the PatientLifting the Patient Lifting the Patient Moving the PatientTransferring the Patient Transferring to a Commode Chair Transferring to a Commode ChairTransferring to a Bed Transferring to a WheelchairSymptoms Faults Solution TroubleshootingMaintenance Safety Inspection Checklist MaintenanceCleaning the Sling and the Lift Detecting Wear and DamageLubricating the Lift Adjusting the BaseAdjusting the Knee Pad Height Replacing the Electric Actuator Replacing the Electric ActuatorUSA Limited Warranty
Related manuals
Manual 2 pages 56.89 Kb