Invacare RPS350-1 General Guidelines, Weight Limitation, Assembling the Lift, Using the Sling

Page 8

SECTION 1—GENERAL GUIDELINES

SECTION 1—GENERAL GUIDELINES

WARNING

SECTION 1 - GENERAL GUIDELINES contains important information for the safe operation and use of this product.

Check all parts for shipping damage before using. In case of damage, DO NOT use the equipment. Contact the Dealer for further instructions.

The Invacare patient lift is NOT a transport device. It is intended to transfer an individual from one seated surface to another (such as a bed to a wheelchair).

DO NOT attempt any transfer without approval of the patient’s physician, nurse or medical assistant. Thoroughly read the instructions in this Owner’s Manual, observe a trained team of experts perform the lifting procedures and then perform the entire lift procedure several times with proper supervision and a capable individual acting as a patient.

Invacare Stand Assist and Transfer slings are specifically designed to be used in conjunction with Invacare patient lifts. Slings and accessories designed by other manufacturers are not to be utilized as a component of Invacare’s patient lift system. Use the sling that is recommended by the individual’s doctor, nurse or medical assistant for the comfort and safety of the individual that is being lifted.

If the patient lift is used in the area of a shower or bath, ensure that the patient lift is wiped clean of any moisture after use. DO NOT store the lift in a damp area or in a damp condition. Periodically inspect all components of the patient lift for signs of corrosion. Replace all parts that are corroded or damaged.

The stand up lift may be operated by one healthcare professional for all lifting preparation, transferring from and transferring to procedures with a cooperative, partial weight‐bearing patient. However, since medical conditions vary, Invacare recommends that the healthcare professional evaluate the need for assistance and determine whether more than one assistant is appropriate in each case to safely perform the transfer.

The use of the patient lift by one assistant should be based on the evaluation of the healthcare professional for each individual case.

Weight Limitation

DO NOT exceed maximum weight limitation of the patient lift. The weight limitation for the patient lift is 350 lbs.

Assembling the Lift

DO NOT overtighten mounting hardware. This will damage mounting brackets.

Using the Sling

Stand Assist Slings: DO NOT use the stand assist sling in combination with the patient lift as a transport device. It is intended to transfer an individual from one resting surface to another (such as a bed to a wheelchair).

Stand Assist Slings: Before lifting the patient, make sure the bottom edge of the stand assist sling is positioned on the lower back of the patient and the patient’s arms are outside the stand assist sling.

Stand Assist Slings: The belt MUST be snug, but comfortable on the patient, otherwise the patient can slide out of the sling during transfer, possibly causing injury.

Transfer Slings: Before lifting the patient, make sure the bottom edge of the transfer sling is at the base of the spine and the patient’s arms are outside the transfer sling.

Transfer Slings: DO NOT raise the patient to a full standing position while using the transfer sling, otherwise injury may occur.

After each laundering (in accordance with instructions on the sling), inspect sling(s) for wear, tears, and loose stitching. Bleached, torn, cut, frayed, or broken slings are unsafe and could result in injury. Discard immediately.

DO NOT alter slings.

Be sure to check the sling attachments each time the sling is removed and replaced, to ensure that it is properly attached before the patient is removed from a stationary object (bed, chair or commode).

If the patient is in a wheelchair, secure the wheel locks in place to prevent the chair from moving forwards or backwards.

Stand Up Patient Lift

8

Part No. 1078984

Image 8
Contents Stand Up Patient Lift RPS350-1 Accessories Warning Symbol LegendTable of Contents Limited Warranty Special Notes Label Location Product Parameters RPS350-1 Stand Up Patient LiftWeight Limitation Using the SlingGeneral Guidelines Assembling the LiftPerforming Maintenance Operating the LiftLifting the Patient Transferring the PatientAssembly Install the Shifter HandleUnpacking the Patient Lift Assembling the Patient LiftAttaching the Battery Charger Mounting Bracket to the Wall May occurUsing the Emergency Stop OperationLocking/Unlocking the Rear Casters Raising/Lowering the Patient LiftCharging the Battery Activating a Mechanical Emergency ReleaseLifting the Patient Positioning the Stand Up LiftLifting the Patient Moving the Patient Lifting the PatientTransferring the Patient Transferring to a Commode Chair Transferring to a Commode ChairTransferring to a Wheelchair Transferring to a BedTroubleshooting Symptoms Faults SolutionMaintenance Maintenance Safety Inspection ChecklistCleaning the Sling and the Lift Detecting Wear and DamageLubricating the Lift Adjusting the BaseAdjusting the Knee Pad Height Replacing the Electric Actuator Replacing the Electric ActuatorLimited Warranty USA
Related manuals
Manual 2 pages 56.89 Kb