Invacare RPS350-1 user manual Transferring to a Wheelchair, Transferring to a Bed

Page 19

SECTION 5—TRANSFERRING THE PATIENT

Transferring to a Wheelchair

NOTE: For this procedure, refer to FIGURE 5.2.

1.Ensure the legs of the lift with the patient in the sling are in the open position.

2.Move the wheelchair into position. Refer to Detail “A”.

3.Engage the rear wheel locks of the wheelchair to prevent movement of the wheelchair. Refer to Detail “B”.

WARNING

DO NOT place the patient in the wheelchair if the locks are not engaged. The wheelchair wheel locks MUST be in a locked position before lower- ing the patient into the wheelchair for transport. Otherwise, injury may result.

4.Position the patient over the wheelchair.

5.Lower the patient into the wheelchair.

6.Unhook the sling from all attachment points on the lift. Refer to Detail “C”.

7.Instruct patient to lift their feet off the footplate. Assist the patient if necessary.

8.Remove the sling from around the patient.

9.Pull the lift away from the wheelchair.

Transferring to a Bed

NOTE: For this procedure, refer to FIGURE 5.3.

NOTE: The lower center of gravity provides stability making the patient feel more secure and the lift easier to move.

NOTE: The lift arms will stay in position until the DOWN button on the hand control is pressed.

1.Position the patient as far over the bed as possible.

NOTE: If patient is being transferred from a surface that is lower than the bed, raise the patient above the surface of the bed. The patient should be elevated just high enough to clear the bed with their weight fully supported by the lift.

2.Press the DOWN button and lower the patient onto the bed.

WARNING

Invacare recommends locking the rear swivel casters ONLY when positioning or removing the sling from around the patient.

3.Lock the rear swivel casters on the stand up lift.

4.Unhook the sling from all attachment points on the lift.

5.Instruct the patient to lift their feet off of the footplate. Assist the patient if necessary.

6.Remove the standing or transport sling from around the patient.

7.Unlock the rear swivel casters and pull the lift away from the bed.

DETAIL “A”

DETAIL “B”

DETAIL “C”

FIGURE 5.2 Transferring to a Wheelchair

FIGURE 5.3 Transferring to a Bed

Part No. 1078984

19

Stand Up Patient Lift

Image 19
Contents Stand Up Patient Lift RPS350-1 Symbol Legend Accessories WarningTable of Contents Limited Warranty Special Notes Label Location RPS350-1 Stand Up Patient Lift Product ParametersAssembling the Lift Weight LimitationUsing the Sling General GuidelinesTransferring the Patient Performing MaintenanceOperating the Lift Lifting the PatientAssembling the Patient Lift AssemblyInstall the Shifter Handle Unpacking the Patient LiftMay occur Attaching the Battery Charger Mounting Bracket to the WallRaising/Lowering the Patient Lift Using the Emergency StopOperation Locking/Unlocking the Rear CastersActivating a Mechanical Emergency Release Charging the BatteryPositioning the Stand Up Lift Lifting the PatientLifting the Patient Lifting the Patient Moving the PatientTransferring the Patient Transferring to a Commode Chair Transferring to a Commode ChairTransferring to a Bed Transferring to a WheelchairSymptoms Faults Solution TroubleshootingDetecting Wear and Damage MaintenanceMaintenance Safety Inspection Checklist Cleaning the Sling and the LiftAdjusting the Knee Pad Height Adjusting the BaseLubricating the Lift Replacing the Electric Actuator Replacing the Electric ActuatorUSA Limited Warranty
Related manuals
Manual 2 pages 56.89 Kb