Invacare RPS350-1 user manual Replacing the Electric Actuator

Page 23

SECTION 7—MAINTENANCE

Replacing the Electric Actuator

1.Remove the bottom nut, washer and shoulder bolt that secure the electric actuator to the mast mounting bracket.

2.Rest the lift arm on your shoulder and remove the top nut, bolt, bracket and bushing from the lift arm mounting bracket.

3.Remove the electric actuator.

4.Reverse STEPS 1‐3 to install the new electric actuator.

WARNING

DO NOT overtighten mounting hardware. This will damage mounting brackets.

Bracket

Bolt

Bolt

Washer

Washer Bushing

Bolt

Bolt

Washer

Washer Bushing

FIGURE 7.3 Replacing the Electric Actuator

Part No. 1078984

23

Stand Up Patient Lift

Image 23

Contents Stand Up Patient Lift RPS350-1 Symbol Legend Accessories WarningTable of Contents Limited Warranty Special Notes Label Location RPS350-1 Stand Up Patient Lift Product ParametersAssembling the Lift Weight LimitationUsing the Sling General GuidelinesTransferring the Patient Performing MaintenanceOperating the Lift Lifting the PatientAssembling the Patient Lift AssemblyInstall the Shifter Handle Unpacking the Patient LiftMay occur Attaching the Battery Charger Mounting Bracket to the WallRaising/Lowering the Patient Lift Using the Emergency StopOperation Locking/Unlocking the Rear CastersActivating a Mechanical Emergency Release Charging the BatteryPositioning the Stand Up Lift Lifting the PatientLifting the Patient Lifting the Patient Moving the PatientTransferring the Patient Transferring to a Commode Chair Transferring to a Commode ChairTransferring to a Bed Transferring to a WheelchairSymptoms Faults Solution TroubleshootingDetecting Wear and Damage MaintenanceMaintenance Safety Inspection Checklist Cleaning the Sling and the LiftLubricating the Lift Adjusting the BaseAdjusting the Knee Pad Height Replacing the Electric Actuator Replacing the Electric ActuatorUSA Limited Warranty

Related manuals

Manual 2 pages 56.89 Kb