
Guidance and manufacturer’s
SYSTEMS that are not
Guidance and manufacturer’s
The 2401LM Touchmonitor for Healthcare Applications is intended for use in the electromagnetic environment specified below. The user of the 2401LM Touchmonitor for Healthcare Applications should assure that it is used in such an environment.
Immunity Test | IEC 60601 Test | Compliance | Electromagnetic |
|
| Level | Level |
|
|
|
|
|
|
|
|
|
| Portable and mobile RF communications equipment |
|
|
|
| should be used no closer to any part of the 2401LM |
|
|
|
| Touchmonitor for Healthcare Applications and should |
|
|
|
| assure that it is used in such an environment, |
|
|
|
| including cables, than the recommended separation |
|
|
|
| distance calculated from the equation applicable to the |
|
|
|
| frequency of the transmitter. Recommended |
|
|
|
| separation distance |
|
Conducted RF | 3 Vrms | 3 Vrms | 80MHz to 800 MHz |
|
|
| |||
Radiated RF | 3 V/m | 3 Vrms | 800 MHz to 2.5GHz |
|
IEC | 80 MHz to 2.5 |
| where P is the maximum output power rating of the |
|
| GHz |
|
| |
|
|
| transmitter in watts (W) according to the transmitter |
|
|
|
| manufacturer and d is the recommended separation |
|
|
|
| distance in metres(m) |
|
|
|
| Field strengths from fixed RF transmitters, as |
|
|
|
| determined by an electromagnetic site survey1, |
|
|
|
| should be less than the compliance level in each |
|
|
|
| frequency range2. |
|
|
|
| Interference may occur in the vicinity of equipment |
|
|
|
| marked with the following symbol: |
|
|
|
|
|
|
NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
3.Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the 2401LM Touchmonitor for Healthcare Applications is used exceeds the applicable RF compliance level above, the 2401LM Touchmonitor for Healthcare Applications should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as reorienting or relocating the 2401LM Touchmonitor for Healthcare Applications.
4.Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 Vrms.
| User Manual 2401LM |
© 2013 Elo Touch Solutions, Inc. All rights reserved. | SW200127 Rev A - Page 9 of 32 |