Elo TouchSystems 2401LM user manual General Mounting Information, Rear Vesa Mount

Page 17

Chapter 3: Mounting

General Mounting Information

The OSD text can be rotated through the OSD menu to better suit your mounting orientation.

The holes located on the top and bottom of the Touchmonitor case are for ventilation. Do not block, cover, or insert anything inside the ventilation slots.

Rear VESA Mount

A four-hole 100x100mm mounting pattern for M4 screws is provided on the rear of the monitor. Remove the stand using a Phillips screwdriver to access this mounting interface. The VESA FDMI-compliant mounting is coded: VESA MIS-D, 100, C

	User Manual 2401LM
© 2013 Elo Touch Solutions, Inc. All rights reserved.	SW200127 Rev A - Page 17 of 32

Image 17

Contents SW200127 Rev a Elo Touch Solutions 2401LM TouchmonitorTrademark Acknowledgments DisclaimerSW200127 Rev a Page 3 Medical and Healthcare Application Disclaimer Storag e / Transportation ClassificationStorage / Transportation 10 % t o 90% Altitude O 3,000mStandards EN 60601-1-2 European Standards and ClassificationsEquipment and Systems IEC On Power SupplyElectrostatic Radiated RF Conducted RFIEC MHz to GHzTransmitter 100 Output PowerRated Maximum Table of Contents Product Description PrecautionsIntroduction Unpacking the Touch monitor InstallationConnector Panel & Interfaces Touchmonitor Connections Installing the Touch Technology Software Drivers SW200127 Rev a Page 16 Rear Vesa Mount MountingGeneral Mounting Information Ergotron Stand MountingVesa Mounting Options Operation PowerTouch VideoOn-Screen Display OSD Volume TemperaturePhase OSD TimeoutAudio OSD and Power LockoutsProblem Suggested Troubleshooting Solutions to Common ProblemsTechnical Support Technical AssistanceCare and Handling Safety & MaintenanceSafety Waste Electrical & Electronic Equipment Directive Weee Regulatory Information SW200127 Rev a Page 27 Pcba Ethers PbdeSW200127 Rev a Page 29 Warranty Information Agency Certifications Altitude Installing Software Drivers, 15 internal speakersIndex Check out our website Getting in Touch with Us