Comfort PLUS Whirlpool Bath
Drop-in Installation
Before you begin your installation, please read the following:
•Observe all local and building codes.
•Determine which tools will be used during the installation.
•Additional bathtub drain parts and plumbing are commercially available at plumbing and hardware stores.
•Drain/Overflow
English
Complete the bathtub surround installation.
1Install drain/overflow according to the manufacturer’s instructions. Refer also to the Technical Specifications Manual.
Watertight installation of the drain is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi Luxury Bath warranty of this product.
2Install the faucet at this time. It is recommended that the faucet be installed by a qualified plumber.
Tile Subfloor
Mortar or Adhesive
Flashing
Sealant
Proper installation of the spout plumbing and compliance with local codes are the responsibility of the installer. Jacuzzi Luxury Bath does not warrant connections of water supply fittings and piping,
fill systems, or drain/overflow systems. Nor is it responsible for damage to the bathtub which may occur during installation.
A
3Prepare the
The template may show guides for more than one bathtub, be certain to select the appropriate guide lines. If under mounting is an option, be careful to select the guide lines that apply to the installation that you are performing.
4Complete all deck finish work. Cover to protect from damaging while placing the bathtub.
5Insulation may be placed within the bathtub surround.
Provide adequate ventilation around the motor/ pump to ensure sufficient airflow and cooling.
6Turn off power supply to dedicated GFCI protected circuits.
7Place a piece of scrap lumber on each of the ends of the cutout – this will be used as a temporary support prior to lowering the bathtub fully into the opening.
8Connect flex water supply lines to faucet and plug power cords into GFCI outlets.
DO NOT use plumbing fixtures or lines to lower the unit. Allow the bathtub to rest on the supports.
9Install the unit, inserting the motor/pump end first, lowering the bathtub into the opening as shown in the illustration.
1˝ x 4˝
(25mm x 101mm) Exploded View Not For Support
Figure 4
Motor/Pump
Scrap Lumber |
|
Tile or Finished | Support Member |
Surface |
|
Figure 5
Motor/Pump
Tile or Finished
Surface
Level Subfloor
Support Member
Figure 6
Installation and Operation | www.jacuzzi.com | Page 11 |