English
Comfort PLUS Whirlpool Bath
Cleanup
To avoid dulling and scratching the surface of the bathtub, never use abrasive cleaners. For most soiled surfaces, a mild liquid detergent and warm water is sufficient. The following is also recommended:
•Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbed with detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as they will damage the bathtub’s surface.
•Paint, tar, or other difficult stains can be removed with Fantastik® or soapy water.
•Minor scratches which do not penetrate the color finish can be removed by lightly sanding with
•Major scratches and gouges which penetrate the acrylic surface will require refinishing. Call Jacuzzi Luxury Bath to find a service agent in your area.
General Operation Information
All bathtubs manufactured by Jacuzzi Luxury Bath are designed for “fill and drain,” which means the bathtub should be drained after each use and filled with fresh water by the next bather. This is a health precaution, as these bathtubs are not designed to hold water continuously like pools or spas.
Close the drain and fill the bathtub until water is at least 1˝ to 2˝ (25mm to 51mm) above the highest jet (see water line indicated in the illustration). Do not turn on the whirlpool system at any time if the jets are not completely immersed in water. Running the whirlpool system when there is insufficient water in the bathtub could result in water spraying outside the bath area. Running the whirlpool system without water will damage the recirculating pump.
Fill to at least 1˝ to 2˝ above highest jet
Figure 13
When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed out of the unit. To prevent this, you must turn unit OFF before exiting bathtub.
Whirlpool Operation
ON: Press the jet button once to turn the whirlpool jets ON.
G
OFF: Press the jet button a second time to turn the whirlpool jets OFF.
Chromatherapy (Light) Operation
Press light button 1st time:
Turns colored lighting ON, use up and down buttons to start color scroll or select alternate color.
Press light button 2nd time:
Turns white lighting ON, use up and down buttons to select intensity of white light.
Press light button 3rd time:
Turns all lighting OFF
Page 14 | www.jacuzzi.com | Installation and Operation |