Comfort PLUS Whirlpool Bath
Chromatherapy (Light) Operation (Cont)
Colored Lighting Operation
The colored lighting default is constant blue. Pressing the ( ) button activates color scroll in this order: blue, teal, green, yellow, orange, red, pink, purple and then returns to blue and continuously repeats. To stop on a selected color, press the ( ) button again. Pressing the ( ) button activates color scroll in this order: blue, purple, pink, red, orange, yellow, green, teal and then returns to blue and continuously repeats. To stop on a selected color, press the ( ) button again.
White Lighting Operation
There are five white light intensities. Press the ( ) button to increase light intensity. Press the ( ) button to decrease light intensity.
English
Air Flow (if equipped)
Turn the left air valve dial to active the left air valves. Turn the right air valve dial to activate the right air valves.
The amount of air induced into the whirlpool jets can be controlled from maximum to none.
Turn the dial clockwise to reduce |
|
|
| Turn the dial |
the air flow |
|
|
| air flow clockwise to reduce the air flow |
Figure 14
Controlling Whirlpool Direction and Flow
Direction -
All Jacuzzi jets, except the rotating neck jets, can be directionally adjusted. To change the direction of the water flow, swivel the jet nozzle to the desired angle. The jets can be directed individually toward any location on your body to provide a hydromassage.
The jets can also be adjusted so that they all point in the same direction (clockwise or counterclockwise) to circulate the water in a circular motion around the bath, causing a total whirlpool effect.
Water Force -
Most Jacuzzi jets are designed for flow adjustment. For robust action, increase the force of the flow by rotating the nozzle, or face, to the left (counterclockwise). For a more gentle effect, or to close off the jet, rotate the nozzle, or face, to the right (clockwise).
Closing one or more jets can increase the water force in the remaining jets.
The rotating neck jets, and some AccuPro™ jets, cannot be adjusted for water force.
Never run the whirlpool system with all the jets closed.
Multidirectional Jets
Figure 15
Purging the Whirlpool System
To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub after each use using, Systems Clean™, our exclusive
Installation and Operation | www.jacuzzi.com | Page 15 |