Jacuzzi HE96000 manual Roughing-In Reference Corner, Tara Plus Right-hand Back Motor

Comfort PLUS Whirlpool Bath

Roughing-In Reference - Corner

		60"
	60"	Service
61-5/8"		Access
Ref.	14" x 4"*
	Heater	Motor
27-1/4"		27-1/4"
35"	46"	35"
		44"
	Opt. Service Access
	- 2" x 4" Stud
	TARA™PLUS, Right Hand
Motor	60"
12" H x 24"L
Service Access		60"
		61-5/8"
		Ref.
Opt. Service	14" x 4"*
	Heater (S)
Access
27-1/4"		27-1/4"
35"	46"	35"
44"
	- 2" x 4" Stud
TARA™ PLUS Left-hand BACK MOTOR
		Motor
		60"
	60"	12" H x 24"L
61-5/8"		Service Access
Ref.	14" x 4"*
		Opt. Service
	Heater (S)
		Access
27-1/4"		27-1/4"
35"	46"	35"
		44"
	- 2" x 4" Stud

TARA™ PLUS Right-hand BACK MOTOR

58"	58"
(1473 mm)	(1473 mm)
59"
Ref.	Motor
Drain Cutout
25-1/2"	Heater
	25-1/2"
(648 mm)	(648 mm)
	45-9/16"
	(1157 mm)

TARA PLUS RH CUTOUT

58"		58"
(1473 mm)	Motor	(1473 mm)
59"
Ref.	Heater
		Drain Cutout
25-1/2"		25-1/2"
(648 mm)	45-9/16"	(648 mm)
	(1157 mm)

CUTOUT

TARA™PLUS Left-Hand BACK MOTOR

	58"	58"
	(1473 mm)	(1473 mm)
59"	Motor
Ref.	Heater
	Drain Cutout
	25-1/2"	25-1/2"
(648 mm)		(648 mm)
	45-9/16"
	(1157 mm)

CUTOUT

TARA™PLUS Right-Hand BACK MOTOR

English

*Add ¼˝ (6mm) to this dimension when roughing-in for 3-wall niche.

1.The overall dimensions are nominal with a tolerance of +0 and -¼˝ (6mm).

2.Service Access dimensions given are minimum. Service access is still required for units that do not have pre-installed Pump/Motor.

3.Measurements inside each unit represent cutout in floor to allow for drain/overflow.

4.All measurements are in inches. To convert to millimeters, multiply inches by 25.4.

5.Not all export units come with pre-installed Pump/Motor.

SUPPORT FOR CORNER BATHS

APPLY	H
ADHESIVE

2" x 4" STUD

Installation and Operation www.jacuzzi.com Page 25