Comfort PLUS Whirlpool Bath
Subfloor
Prepare the subfloor for the drain and ensure that the area is level.
1The drain/overflow of the bathtub extends below the bottom of the bathtub. Identify the drawing in the Technical Specifications Manual that corresponds with your bathtub.
2Make appropriate cuts to the subfloor to accommodate the drain.
3Jacuzzi’s
4If the subfloor is not level, you must level the entire surface prior to installing the bathtub. The materials used will insure that the bathtub is supported from the bottom. These materials include: leveling compound, mortar, plaster or minimal expansion structural foam (having a density of a minimum 5lbs/cubic foot). The bathtub must remain level in order for it to drain properly and must make contact with the leveling material. Both sides of a joint or splice of subfloor should be level to each other.
English
Electrical Connections
Risk of electric shock. Connect only to a circuit protected by a GFCI.
When using electrical products, basic precautions should always be followed:
•Always follow local building and electrical codes.
•Grounding is required. The unit should be installed and grounded by a qualified electrician.
Two separate GFCI protected circuits are required.
A separate, 120VAC, 15 AMP GFCI circuit is required for the pump/motor.
A separate 120VAC, 15AMP, GFCI protected circuit is required for the heater.
Risk of component overheat. Do not use electric extension cord to power this unit.
Operating the motor/pump without enough water in the bathtub can cause permanent damage to the pump.
Pump/Motor with Heater
Electrical outlets must be mounted 4˝ (101mm) above the floor line, or in accordance with local building and electrical codes.
-The pump/motor and heater require a dedicated 120VAC, 15 Amp GFCI protected circuit for each. The electrical outlets are not provided.
-Power cord from the pump/motor is routed to a control box t the factory. A supplied power cord from the control box with a 120VAC, 15 AMP plug connects to the
-Bonding lugs are provided on the motor to satisfy local electrical codes.
-At initial
4˝
(101mm)
Figure 2
If the GFCI units indicate a malfunction, per manufacturer’s instructions, turn OFF power and do not use the bathtub until the source of the problem has been identified and corrected.
Installation and Operation | www.jacuzzi.com | Page 9 |