Graham Field lf 1031 Lifting the patient from the floor, Lowering the patient to the floor

Page 16

2.Center the patient over the bed, and rotate the patient to face the foot section of the bed. SLOWLY release the pressure knob by turning it counter-clockwise for gradual lowering of the patient (LF1031) or using the hand control pendant (LF1041). Carefully lower the patient onto the bed. Support the patient’s head, if necessary, while being lowered. Remove the sling by reversing the procedures used when lifting patient from bed.

Lifting the patient from the floor

1.Position the patient lift behind the patient, placing a pillow over the base to protect and support the patient’s head and neck. Place the patient's head carefully on the base. The patient lift should be positioned with the spreader bar centered over the patient.

2.Lower the spreader bar. Attach the sling to the spreader bar hooks.

3.Lift the patient up above the floor. Position the patient in the sling by pulling the handle on the back of the sling. Turn the patient to face the lifting column, and place the patient’s feet on the base, straddling the column for extra stability.

Lowering the patient to the floor

1.Place a pillow on the base to protect the patient’s head and neck (this is unnecessary when using a sling with a head support).

2.Reverse the above procedures to lower.

Transferring the patient from a chair to a wheelchair or commode chair

Info: GF Health Products, Inc. recommends that two attendants be used when transferring a patient to and from a wheelchair.

1.Fold the sling.

2.While maintaining support, gently lean the patient forward. Place the folded sling behind the patient’s back and push it down until it touches the seat of the chair.

3.Use the loops to pull the leg sections of the sling forward and beneath the patient’s thighs. Then cross the loops, one through the other.

4.Move the patient lift around to the front of the chair.

5.Hook all sling loops onto the spreader bar.

6.Carefully raise the patient.

7.The second attendant should now move the wheelchair into position.

8.Engage the wheelchair wheel locks to prevent movement.

WARNING: Before transfer, ensure wheelchair wheel locks are in locked position. Wheelchair wheel locks must be in a LOCKED POSITION before lowering the patient into the wheelchair, or unexpected wheelchair movement could result, which may result in serious personal injury to both the patient and the attendants.

9.Position the patient over the wheelchair with their back against the back of the wheelchair.

10.SLOWLY lower the patient into the wheelchair.

11.With one attendant behind the wheelchair and the other operating the lift, the attendant behind the chair should pull back on the handle or sides of the sling to place the patient into the back of the chair. This will maintain a good center of balance and prevent the chair from tipping forward.

LF1031-INS-LAB-RevD12

16

Image 16
Contents LF1031-INS-LAB-RevD12 GF Health Products, Inc Contents Introduction Safety Precautions LF1031-INS-LAB-RevD12 Features Handling Procedures Shipping and Transportation InstructionsUnpacking InspectionAssembly Instructions ComponentsAssembly Base and mast assemblyLF1031-INS-LAB-RevD12 LF1041 only attaching Power bracket ComponentsActuator / motor LF1041 only electrical power connections LF1041 only charging the battery LF1041 only control box power switch emergency stop buttonLF1041 only Emergency Procedures Operating InstructionsLifting the patient from a bed Lift Operation Patient TransferLowering the patient onto a bed Lifting the patient from the floor Lowering the patient to the floorRemoving the sling Care and Maintenance BatteryBefore Each USE LubricationChecking for Damage and Wear CleaningCare of Slings LF1031 only Installation of 1010S005 Hydraulic Pump Removal of Existing PumpInstallation of New Pump Maintenance Schedule Troubleshooting LF1031 Hydraulic Patient Lift Symptom Possible Cause ActionSpecifications Limited Warranty GF Health Products, Inc. Graham-Field Index