LF1031 ONLY: INSTALLATION OF 1010S005 HYDRAULIC PUMP
Removal of Existing Pump
existing pump
existing pump |
upper boom | boom |
bracket |
|
detach existing pump from upper boom
lower mast
mast bracket
detach existing pump from lower mast
1.Follow the instructions in this section to remove the existing pump, shown at above left. If installing pump for the first time, proceed to Installation of new pump on next page.
2.Detach the top of the existing pump from the upper boom bracket, as shown at above center: Use two 9/16" wrenches to remove the hardware that secures top of pump to upper boom bracket. This will free the pump to rotate downward.
3.Detach the bottom of the existing pump from the lower mast bracket, as shown at above right. Use two 9/16" wrenches to remove the hardware that secures bottom of pump to lower mast bracket. This will free the pump — take care that it does not fall.
| 20 |