Kenwood TS-440S manual Other Accessories, Meters bands, MC-60A PS-50 MC-85MC-55 PS-430 MC-80MC-42S

Page 29

6-4. OTHER ACCESSORIES

.PS-50 HEAVY DUTY DC POWER SUPPLY

Designed to match the TS-440S. Supplies regulated

13.8VDC at 20 A with built-in cooling fan and pro- tection circuits for maximum relliability.

.PS-430 DC POWER SUPPLY

The PS-430 is a regulated DC power supply with high current capability. The output is 13.8 VDC/20 A (in- termittent). Since terminals for 13.8 VDC/1 0 A are also provided, in addition to an output power cable for use with the TS-440S, the PS-430 can be used as the pow- er source for another low power mobile transceiver such as a 2-meter rig.

.AT -440 AUTOMATIC ANTENNA TUNER UNIT The AT -440 Automatic Antenna Tuner unit can be in- stalled in the TS-440S. The tuner covers all amateur bands from 80 through 10 meters, including the new WARC bands. Matching capability is 20 to 150 ohms, unbalanced.

.AT -250 AUTOMATIC ANTENNA TUNER

The AT -250 Automatic Antenna Tuner covers 160 through 10 meters bands.

.AT -230 ANTENNA TUNER

The AT -230 Antenna Tuner covers 160 through 10 meters bands.

.AT-130 ANTENNA TUNER

The AT -130 Antenna Tuner covers 80 through 10

meters bands.

.MC-85 MICROPHONE (8-pin)

The MC-85 is a unidirectional high-class electret con- denser microphone provided with the output selective switch, audio level compensation circuit, low cut filter, level meter, PTT and LOCK switches. An 8-pin cable is provided, with optional cables, up to three outputs are possible.

.MC-80 MICROPHONE (8-pin)

The MC-80 is an omnidirectional electret condenser

microphone provided with UP/DOWN switches,

volume adjustment for output level, PTT and LOCKswitches, built-in pre-amplifier.

.MC-60A MICROPHONE (S-pin)

The zinc die-cast base provides high stability, and the MC-60A is complete with PTT and LOCK switches, UP/DOWN switches, and impedance selector switch and a built-in pre-amplifier.

.MC-55 MOBILE MICROPHONE (8-pin)

The MC-55 provides UP/DOWN switches, LED display

for switching transmit or receive, adjustable micro- phone gain, automatic receive returning circuit (approx.

5 minutes) and many functions.

.MC-42S UP/DOWN HAND MICROPHONE

The MC-42S is handy dynamic microphone with PTT switch and UP/DOWN switches.

.LF-30A LOW PASS FILTER

AT -250

MC-60A

PS-50

MC-85MC-55

PS-430

MC-80MC-42S

30

Image 29
Contents HF TRANSCEIVERTS-440S Kenwood Corporation Contents Wide dynamic range Switchable if bandwidthBuild-in XIT 0- 6.19-7/~oFixed Station Precaution~~~~~~~.~~ S-44~S To AC outlet To antennaJustment MobileAntenna II CJ,.-,, Lt.U @ RIT/XIT control@ RF gain control @ AF gain control@ Notch switch @ AGC switch@ F.LOCK switch @ 1 MHz step switch@ ATT Attenuator switch @ Standby switchNB Noise Blanker switch @ Voice switchANT ~=\~~GND @ ACC 2 jackGND PIN==---= ReceiveCW zero-beat operation QuencyTransmit ~udio signal~1ir FM mode CW modeBand TainedCussed below Dual Digital VFOsChanged ~i, CH ,j MemoryOFF ScanTwo methods may be used to clear a memory AgainMemorychannellockout PGS-1PG.S-1 Mode AfskOperation with a Linear AMPLI- Fier CrowdedReceiver Section Transmitter SectionCircuit Board Description General DescriptionCleaning ServiceGeneral Information Case of Difficul TVMicroprocessor Reset Microprocessor BACK-UP Lithium BatteryOrdering Spare Parts ModeBottom view Adjustments066 COt,~ Rear panel Guaranteed attenuation More than 80 dB Crystal Filter Installation Center frequency Passband widthSse Voice Synthesizer Unit VS-1 InstallationVS-1 UP/DOWN Interface IC KIT IC-10 InstallationMode RIT/XITMC-60A PS-50 MC-85MC-55 PS-430 MC-80MC-42S Other AccessoriesMeters bands 430 SP-50 TL-922A/TL-922 MB-430HS-6HS-5 ~32Earpads are provided Specifications T91-0352-05 AccessoriesCopy Dynamic microphone Except Europe and U.KAntenna Antenna installationMust Contact MOBll Operation InstallationTerference Noise reduction Radio Frequency Allocation Radio Frequency AllOCATIONBands
Related manuals
Manual 56 pages 11.98 Kb Manual 57 pages 45.45 Kb