Kenwood TS-440S manual MB-430, 430 SP-50 TL-922A/TL-922

Page 30

.MB-430 MOBILE MOUNT

The Mobile Mount MB-430 allows easy installation and removal of the TS-440S. The MB-430 can either be suspended from the dashboard or attached to the

transmission tunnel or a center console. The tran- sceiver tilt angle can be adjusted 5 steps.

.PG-2C DC POWER CABLE

.MA-5 5 BAND HELICAL TYPE HF MOBILE

ANTENNA

.VP-1 BUMPER MOUNT FOR MA-5

.SP-430 EXTERNAL SPEAKER

The SP-430 is an attractive, compact external speak- er. This low-distortion speaker provides clear reproduc- tion of the high-quality audio obtained from the transceiver.

.SP-50 MOBilE SPEAKER (8 ohms)

Compact and smart high quality external speaker pro-

vides flexibility of installation for maximum con- venience.

.SP-41 COMPACT MOBILE SPEAKER (4 ohms)

.TL-922A/TL-922 HF LINEAR AMPLIFIER (Not for aSK operation.)

The TL-922A/922 is an HF linear amplifier operating

at maximum legal power, and employing a pair of 3-500l high performance transmitting tubes. TL-922A (without 10 meter band) is available only in U.S.A.

.SM-220 STATION MONITOR

Built around a basic 10 MHz oscilloscope, the SM-220 station monitor features, in combination with a built- in two-tone generator, a variety of waveform-observing capabilities.

.PC-1A PHONE PATCH

(Available only where phone patch operation legal.) Hybrid phone patch with VU meter for null and audio

gain measurements. The PC-l A Phone Patch provides interface between the transceiver and telephone line.

Providing excellent performance, it is designed with high isolation between receive input and transmit out- put. Its compact design permits easy installation in a limited space. (FCC Part 68 registered)

","

SP-41

MB-430

SM-220

S P-430

SP-50

TL-922A/TL-922

 

31

Image 30
Contents HF TRANSCEIVERTS-440S Kenwood Corporation Contents Build-in XIT Switchable if bandwidthWide dynamic range 0- 6.19-7/~o~~~~~~~.~~ S-44~S PrecautionFixed Station To AC outlet To antennaMobile AntennaJustment @ RF gain control @ RIT/XIT controlII CJ,.-,, Lt.U @ AF gain control@ F.LOCK switch @ AGC switch@ Notch switch @ 1 MHz step switchNB Noise Blanker switch @ Standby switch@ ATT Attenuator switch @ Voice switchANT GND @ ACC 2 jack~=\~~GND PINCW zero-beat operation Receive==---= Quency~udio signal ~1irTransmit Band CW modeFM mode TainedDual Digital VFOs ChangedCussed below Memory ~i, CH ,jTwo methods may be used to clear a memory ScanOFF AgainPGS-1 PG.S-1Memorychannellockout Operation with a Linear AMPLI- Fier AfskMode CrowdedCircuit Board Description Transmitter SectionReceiver Section General DescriptionGeneral Information ServiceCleaning Case of Difficul TVOrdering Spare Parts Microprocessor BACK-UP Lithium BatteryMicroprocessor Reset ModeAdjustments Bottom view066 COt,~ Rear panel Center frequency Crystal Filter InstallationGuaranteed attenuation More than 80 dB Passband widthVoice Synthesizer Unit VS-1 Installation VS-1Sse Mode Interface IC KIT IC-10 InstallationUP/DOWN RIT/XITOther Accessories Meters bandsMC-60A PS-50 MC-85MC-55 PS-430 MC-80MC-42S MB-430 430 SP-50 TL-922A/TL-922~32 Earpads are providedHS-6HS-5 Specifications Copy AccessoriesT91-0352-05 Dynamic microphone Except Europe and U.KAntenna installation AntennaMOBll Operation Installation TerferenceMust Contact Noise reduction Radio Frequency AllOCATION BandsRadio Frequency Allocation
Related manuals
Manual 56 pages 11.98 Kb Manual 57 pages 45.45 Kb