Ant

3-1-2. .Rear panel

CD ACC 3 terminal

Spare RCA type terminal. No internal connections have

been made.

@ AFSK IN terminal

AFSK input terminal.

@ AFSK OUT terminal

Constant level AF output terminal for AFSK operation,

@ ANTI VOX control

vox operations are sometimes difficult with high speaker volume control settings. The ANTI VOX con- trol is used to reduce the tendency of the VOX to acti- vate from inputs from the speaker. The ANTI VOX control is not active when headphones are connect-

ed, for obvious reasons!

@ DELAY control

This control adjusts the "hang-time" that the radio will remain keyed after voice input has stopped.

DELAY

{(§)\

@ VOX GAIN control

This control adjusts the sensitivity of the VOX ampli- fier. Adjust this control for your personal preference.

VOX GAIN

(6)'\

CD ACC 1 jack

This jack is designed for connection of the 6-pin DIN connector supplied with the optional interface unit.

@ EXT. SP (External speaker) jack

This jack is for connection of an external speaker.

@ DC power connector

This is used to connect the DC power supply.

@ KEY jack

Using shielded line, connect a 1/4" phone plug to this jack for CW operation. Open-terminal voltage is approx-

imately 5.5 VDC.

([j)	ANT	(Antenna) connector
This	UHF	connector	should	be attached	to	a	suitable
anten~a	for	transmitting	and	receiving.	The	antenna ca-
ble should		be 50-ohm	coax,	terminated	with	a	PL-259
connector.

@ GND (Ground) terminal

To prevent electric shock, as well as RFI and BCI, con-

nect the transceiver to a good earth ground.

~,CD.