Invacare EX2 warranty Seat and Back, Replacing Back Upholstery, Replacing Seat Upholstery

SECTION 6—SEAT AND BACK

SECTION 6—SEAT AND BACK

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Replacing Back Upholstery

NOTE: For this procedure, refer to For this procedure, refer to FIGURE 6.1.

1.Remove the eight mounting screws and washers that secure the existing back upholstery to the back canes.

2.Remove existing back upholstery from the back canes.

3.Securely tighten the new back upholstery to the back canes with the phillips screws and washers. The following chart determines the number of mounting screws for each seat depth.

Replacing Seat Upholstery

NOTE: For this procedure, refer to FIGURE 6.4.

1.Remove the eight phillips screws and washers that secure the existing seat upholstery to the crossbraces.

2.Remove the existing seat upholstery from the crossbraces.

3.Ensure positioning of seat positioning strap (if used). Refer to Installing the Seat Positioning Strap on page 39.

4.Install new seat upholstery by reversing STEPS 1‐2.

Washers

Mounting

Screws

Mounting Screws	16-inch Seat
Back Upholstery	Depth

Seat

Upholstery

Wheelchair

Frame

Washers

FIGURE 6.1 Replacing Back/Seat Upholstery

Tracer® EX2 26 Part No. 1110546