Invacare EX2 warranty Raising/Lowering Elevating Legrest Assembly, Fixed Frame

SECTION 4—FRONT RIGGINGS

Fixed Frame

NOTE: For this procedure, refer to FIGURE 4.4

1.Remove impact guards and/or calf strap, if necessary.

2.Loosen, but do not remove the bolt and locknut that secure the lower footrest assembly to the upper footrest support.

3.Reposition the lower footrest assembly to the desired height.

4.Securely tighten the bolt and locknut.

5.Repeat this procedure for the other footrest, if necessary.

6.Replace impact guards and/or calf strap, if necessary.

Wheelchair Frame

Footplate

Assembly

Bolt and

Locknut

FIGURE 4.4 Fixed Frame

Raising/Lowering Elevating Legrest Assembly

WARNING

Ensure hands and fingers are clear of elevating legrest mechanism before pushing release lever to lower the elevating legrest. Otherwise injury may occur due to pinch points.

The wheelchair user’s leg MUST be supported by an assistant before attempting to lower legrest.

NOTE: For this procedure, refer to FIGURE 4.5.

1.To raise the elevating legrest, the assistant should hold the support tube and raise the elevating legrest until the desired height is obtained.

2.To lower the elevating legrest, perform the following:

A.Support user leg with one hand.

B.Push release lever downward with other hand.

C.Gently, lower user leg down and rest against the legrest.

Release Lever

Support

Tube

FIGURE 4.5 Raising/Lowering Elevating Legrest Assembly

Part No. 1110546 21 Tracer® EX2