Invacare EX2 warranty Options, Installing Amputee Bracket

Page 38

SECTION 11—OPTIONS

SECTION 11—OPTIONS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Installing Amputee Bracket

NOTE: For this procedure, refer to FIGURE 11.1 on page 38.

1.Refer to the following chart or FIGURE 11.1 to determine the mounting position of the amputee bracket:

SEAT-TO-FLOOR

*BRACKET

AXLE SPACER POSITION

SIDE OF

AXLE MOUNTING

 

 

(ON BRACKET)

WHEELCHAIR

POSITION

 

 

 

 

(ON WHEELCHAIR)

 

 

 

 

 

ADULT

A

DOWN

RIGHT

TOP

ADULT

B

DOWN

LEFT

TOP

HEMI

B

UP

RIGHT

BOTTOM

HEMI

A

UP

LEFT

BOTTOM

 

 

 

 

 

*NOTE: ʺAʺ and ʺBʺ are stamped on the sides of the amputee bracket.

2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1. NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.

3.Install the two hex screws and locknuts that secure the amputee bracket to the wheelchair.

4.Install the rear wheels onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 30.

Bracket “A”

Bracket “B”

Locknuts

Adult Right

Axle Spacer Toward Outside

of Wheelchair

LeftRight

Adult Left

Axle Spacer Toward Outside

of Wheelchair

Rear View of

Amputee Bracket

Hex Screws

Hemi Left

Hemi Right

FIGURE 11.1 Installing Amputee Bracket

Tracer® EX2

38

Part No. 1110546

Image 38
Contents Tracer EX2 Accessories Warning Special Notes Wheelchair TIE-DOWN Restraints and Seat Positioning StrapsLabel Location Important NoticeTypical Product Parameters Anti-Tippers General GuidelinesStability All Models Operating InformationImmediately Weight Training/Weight Limitation Stability and Balance SAFETY/HANDLING of WheelchairsSafety/Handling of Wheelchairs Coping With Everyday ObstaclesDo not tip the wheelchair without assistance Reaching, Leaning and Bending ForwardReaching and Leaning Backwards Method 1 Wheelchair With Step Tubes Method 1 Wheelchair With Step TubesEscalators StairwaysTransferring To and From Other Seats Unfolding and Folding WheelchairFolding Hammock or Sling Seat Models Folding WheelchairDo not allow upholstery to hang between the cross braces Safety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistMaintenance Inspect/Adjust WeeklySafety INSPECTION/TROUBLESHOOTING Troubleshooting Right/Left Wheels Performance Flutter Rattles ChairFront Riggings Installing/Removing Front RiggingsAdjusting Footplate Height Bolt-In-Place Spring ButtonRaising/Lowering Elevating Legrest Assembly Fixed FrameInstalling Impact Guards/Calf Strap Replacing Heel LoopReplacing Heel Loop Adjusting Armrest Height ArmsRemoving/Installing Armrests Installing ArmrestReplacing Seat Upholstery Seat and BackReplacing Back Upholstery Adjusting the Seat Width Swingaway Front RiggingsDetail B Crossbrace Removing Lower Mounting Hardware Removing/Installing Rear Wheels Rear WheelsReplacing/Repairing Rear Wheel Tire Replacing Rear Wheel HandrimReplacing Front Casters Adjusting ForksFront Casters Replacing/Repairing Front Caster Tire Replacing Front CastersInstalling/Adjusting Anti-tippers ANTI-TIPPERS/WHEEL LocksUsing/Adjusting Patient Operated Wheel Locks Adjusting the Anti-TippersUsing Patient Operated Wheel Locks Seat to Floor Changing Seat-to-Floor HeightInstalling Amputee Bracket OptionsInstalling Crutch and Cane Carrier Installing the Seat Positioning StrapLimited Warranty
Related manuals
Manual 30 pages 6.48 Kb