Invacare EX2 warranty Maintenance, Inspect/Adjust Weekly

Page 16

SECTION 3—SAFETY INSPECTION/TROUBLESHOOTING

Inspect/Adjust Weekly

Ensure that the wheel locks prevent the wheelchair from moving when engaged.

Inspect tires for flat spots and wear.

Check pneumatic tires for proper inflation.

If equipped, check that quick‐release axles lock properly. Lubricate if necessary.

Inspect rear wheels for cracked, bent or broken spokes.

Ensure all spokes are uniformly tight.

Inspect axle assembly for proper tension by spinning caster. Caster should come to a gradual stop.

Inspect front caster for cracked, bent or broken spokes.

Ensure that casters are free of debris.

Inspect/Adjust Monthly

Ensure that the wheelchair rolls straight (no excessive drag or pull to one side).

Check that the wheel locks do not interfere with tires when rolling.

Check that the wheel lock pivot points are free of wear and looseness.

Inspect seat and back for loose or broken hardware.

Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify hardware that attaches strap to frame is secure and undamaged. Replace if necessary.

Inspect back cane hand grips for wear/looseness/deterioration.

Adjust front casters/forks bearing system if wheel wobbles noticeably or binds to a stop.

Ensure wheel bearings are clean and free of moisture.

Check headtube locknuts for tightness.

Inspect/Adjust Periodically

Inspect frame and crossbraces for loose or missing hardware.

Inspect for bent frame or crossbraces.

Check that wheel locks are easy to engage.

Inspect seat and backs for rips and sagging.

Check that there is no excessive side movement or binding in the rear wheels when lifted and spun.

Inspect handrims for signs of rough edges or peeling.

Adjust front casters/forks bearing system if wheel wobbles noticeably or binds to a stop.

Ensure wheel bearings are clean and free of moisture.

Inspect casters for cracks and wear.

Ensure that casters are free of debris.

Clean upholstery and armrests.

Check that all labels are present and legible. Replace if necessary.

Maintenance

Maintenance Safety Precautions

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may result.

Tracer® EX2

16

Part No. 1110546

Image 16
Contents Tracer EX2 Accessories Warning Special Notes Wheelchair TIE-DOWN Restraints and Seat Positioning StrapsLabel Location Important NoticeTypical Product Parameters General Guidelines Stability All ModelsAnti-Tippers Operating InformationImmediately Weight Training/Weight Limitation SAFETY/HANDLING of Wheelchairs Safety/Handling of WheelchairsStability and Balance Coping With Everyday ObstaclesReaching and Leaning Backwards Reaching, Leaning and Bending ForwardDo not tip the wheelchair without assistance Method 1 Wheelchair With Step Tubes Method 1 Wheelchair With Step TubesEscalators StairwaysTransferring To and From Other Seats Unfolding and Folding WheelchairDo not allow upholstery to hang between the cross braces Folding WheelchairFolding Hammock or Sling Seat Models Safety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistMaintenance Inspect/Adjust WeeklySafety INSPECTION/TROUBLESHOOTING Troubleshooting Right/Left Wheels Performance Flutter Rattles ChairAdjusting Footplate Height Installing/Removing Front RiggingsFront Riggings Bolt-In-Place Spring ButtonRaising/Lowering Elevating Legrest Assembly Fixed FrameInstalling Impact Guards/Calf Strap Replacing Heel LoopReplacing Heel Loop Adjusting Armrest Height ArmsRemoving/Installing Armrests Installing ArmrestReplacing Back Upholstery Seat and BackReplacing Seat Upholstery Adjusting the Seat Width Swingaway Front RiggingsDetail B Crossbrace Removing Lower Mounting Hardware Removing/Installing Rear Wheels Rear WheelsReplacing/Repairing Rear Wheel Tire Replacing Rear Wheel HandrimFront Casters Adjusting ForksReplacing Front Casters Replacing/Repairing Front Caster Tire Replacing Front CastersInstalling/Adjusting Anti-tippers ANTI-TIPPERS/WHEEL LocksUsing/Adjusting Patient Operated Wheel Locks Adjusting the Anti-TippersUsing Patient Operated Wheel Locks Seat to Floor Changing Seat-to-Floor HeightInstalling Amputee Bracket OptionsInstalling Crutch and Cane Carrier Installing the Seat Positioning StrapLimited Warranty
Related manuals
Manual 30 pages 6.48 Kb