Platform Angle Adjustment
Adjustment Allen screws are provided on each side of the lift platform for adjusting the platform angle. Adjust platform angle as specified on previous page.
To raise the outboard end | Note: Both adjustment screws |
of platform - turn adjustment | must be adjusted equally. |
screw clockwise. |
|
| Apply Loctite® to adjustment |
To lower the outboard end | screws following adjustment. |
of platform - turn adjustment |
|
screw counterclockwise. |
|
Platform Angle
Adjustment Screws
A |
Adjustment Screw | Allen Head |
B |
Turn
counter-
clockwise
to lower
outboard
end of
platform
Turn
clockwise
to raise
outboard
end of
platform
Platform Stop Blocks
Right 
Must make full contact.
Gap not permitted. Wrong
Vertical Stop
Arm Block
C
Stop Block Guideline
All Lift Models
Both stop blocks must make full contact with the edge of vertical arms.
When adjusting platform angle, setting floor level position or adjusting bridging microswitch - ensure both stop blocks are making full contact with the vertical arms.
Vertical Stop
Arm Block
D
Page 7