Multiquip MVC-90L manual Fuel Tank Holds unleaded gasoline. For additional, Smoothly, Flow of fuel

Page 14

MVC-90L PLATE COMPACTOR — COMPONENTS (ROBIN EH172YD4230 ENGINE)

Figure 4. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions & details of operation and servicing. The engine shown above is a ROBIN engine, operation for other types of engines may vary somewhat.

1. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

2. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

CAUTION - Fueling The Engine

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

3. Fuel Tank – Holds unleaded gasoline. For additional

 

information refer to engine owner's manual.

4.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

5.

Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

 

the flow of fuel.

6.

Air Cleaner – Prevents dirt and other debris from entering

 

the fuel system. Remove wing-nut on top of air filter

 

cannister to gain access to filter element.

Operating the engine without an

NOTEair filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

7. Muffler – Used to reduce noise and emissions.

CAUTION - Burn Hazard

Enginecomponentscangenerateextremeheat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

8. Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

9. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operations.

10. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.

11. Oil Dipstick /Filler Port– Remove to determine the amount oil in engine crankcase. Add oil through this filler port.

12. Oil Sensor– In the event of low oil, this sensor will automatically shut-down the engine.

13. Oil Drain Plug– Remove to drain crankcase oil.

PAGE 14 — MVC-90L PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (11/01/05)

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model MVC-90L Proposition 65WARNING Table of Contents Best Deal! Order via Internet Dealers Only Order via Fax Dealers OnlyMVC-90L Plate Compactor Specifications Lbs kgMVC-90L Plate Compactor Dimensions Developed to provide complete MVC-90L Plate Compactor Safety Message Alert SymbolsAlways wear approved respiratory protection when required This reversible plate compactor MVC-90L Plate Compactor Rules for Safe Operation Never operate this equipment withoutLoading and Unloading Crane Never lift the machine while the engine is runningMVC-90L Plate Compactor Operation and Safety Decals Machine Safety DecalsWater Tank Definition of Plate CompactorVibratory Plate Frequency/SpeedSplash plate Counter weightsVibration Case Encloses the eccentric, gears Smoothly Cannister to gain access to filter elementFuel Tank Holds unleaded gasoline. For additional Flow of fuelEngine Oil Check MVC-90L Plate Compactor InspectionBefore Starting Fuel CheckStarting the Engine MVC-90L Plate Compactor START-UP ProcedurePlace the engine ON/OFF switch in the on position Place the engine fuel valve lever to the Open positionNormal Shutdown Placethefuelshut-offleverFigure17 intheOFFpositionOperation Operating the Compactor on High Moisture Content SoilUsing the Compactor Sprinkler System Always move the throttle leverDaily Service MVC-90L Plate Compactor MaintenanceInspection and Maintenance ServiceTables Vibrator Oil Check Engine Oil ReplacementMixture and re-install it back into the air cleaner Tip the compactor to drain the oilChecking the Clutch Belt CheckReplacing theV-belt Replacing the ClutchMVC-90LPLATECOMPACTOR-PREPARATIONFORLONG-TERMSTORAGE Pump StorageMVC-90L Plate Compactor -TROUBLESHOOTING Engine Engine TroubleshootingAir cleaner not clean? MVC-90L Plate Compactor -TROUBLESHOOTING Plate Compactor QTY. Column NO. ColumnPart NO. Column Remarks ColumnMVC-90L Plate Compactor Suggested Spare Parts MVC-90LMVC-90L Plate Compactor Name Plate and Decals Part Name MVC-90L Plate Compactor Body Assy Part Name QTY MVC-90L Plate Compactor Body Assy Cock PT1/4 MVC-90L Plate Compactor -VIBRATOR Assy Part Name QTY Remarks MVC-90L Plate Compactor Clutch ASSY. Oldtype MVC-90L Plate Compactor Clutch ASSY. Oldtype MVC-90L Plate Compactor Clutch ASSY. Newtype Clutch Shaft D19.05/20W Robin EH172YD4230 Engine Crankcase Group Assy Oversize Robin EH172YD4230 Engine Crankshaft Assy NUT Robin EH172YD4230 Engine Intake and Exhaust Group Assy Release Lever Robin EH172YD4230 Engine Governor Assy Governor Lever Robin EH172YD4230 Engine Cooling and Starting Assy Robin EH172YD4230 Engine Cooling and Starting Assy 210-49Robin EH172YD4230 Engine Fuel Group Assy 50-13 Robin EH172YD4230 Engine Carburetor Assy 210-13 210-11210-12 210-14Electric Device Group ASSY. Recoil Start Flywheel CP Robin EH172YD4230 Engine OIL Sensor Assy OIL Sensor CP Terms and Conditions of Sale Parts Page Heres HOW to GET Help Your Local Dealer is

MVC-90L specifications

The Multiquip MVC-90L is a highly versatile and efficient concrete vibrator designed to enhance the performance of contractors in various construction projects. With its powerful Honda engine and robust construction, the MVC-90L stands out as a reliable tool for consolidating concrete, ensuring high-quality finishes for slabs, walls, and other structures.

One of the primary features of the MVC-90L is its Honda GX160 engine, which offers a consistent power output of 5.5 horsepower. This engine is known for its durability and fuel efficiency, providing the necessary power to operate the vibrator effectively. The MVC-90L also includes a centrifugal clutch, providing smooth engagement and disengagement, which contributes to its user-friendly operation.

The design of the MVC-90L prioritizes comfort and ease of use. It is equipped with ergonomic handles and a lightweight frame, making it easy for operators to maneuver on job sites. Additionally, its compact size allows for easy transportation and storage, making it a practical choice for contractors who need to move equipment frequently.

The MVC-90L features a 15-foot flexible shaft coupled with a vibratory head, which ensures an extensive reach for a variety of applications. This flexibility allows users to cover larger areas without needing to reposition the equipment frequently. The vibrator head produces a high frequency of vibration, ensuring efficient concrete consolidation, resulting in a denser and stronger final product.

With a robust construction, the MVC-90L is designed to withstand the rigors of heavy job site use. The materials used in its construction are resistant to wear and tear, ensuring longevity and reduced maintenance costs. This reliability makes it a preferred choice among professionals who demand performance from their equipment.

Multiquip also emphasizes safety features in the MVC-90L design. The vibrating head is engineered to minimize operator fatigue, while the centrifugal clutch helps reduce the risk of accidental starts. The overall design incorporates safety measures to protect both the user and the equipment.

In summary, the Multiquip MVC-90L is a powerful and user-friendly concrete vibrator that offers reliable performance for various construction applications. With its Honda engine, ergonomic design, and efficient operational features, it ensures professional-quality results while promoting safety and ease of use on the job site. Contractors seeking a durable and effective concrete consolidation solution will find the MVC-90L an invaluable addition to their equipment lineup.
Top Page Image Contents