MVC-90L PLATE COMPACTOR — MAINTENANCE
V-Belt Check
CAUTION - Checking and Replacing the
1.Tocheck
Figure 22.V-Belt Cover Removal
2.The
Replacing theV-belt
1.Remove the belt cover.
2.Place an offset wrench (13 mm) or the like on the vibrator pulley (lower) fastening bolt.
3.Using a waste cloth or the like, pull the
4.Check the clutch and replace as necessary, following the procedures listed in Checking the Clutch.
5.Place the
Checking the Clutch
1.With belt cover removed, visually check outer drum of the clutch for seizure and "V" groove for wear or damage.
2.Clean the "V" groove as necessary.
3.Check the clutch lining and shoe for signs of wear. If the shoe is worn, replace the clutch to prevent deficient power transmission and slippage.
Replacing the Clutch
1.
2.Remove bolt at engine power output by tapping an engaged wrench (e.g. tapping with hammer) and rotate the bolt counterclockwise.
3.Remove clutch with a pulley extractor.
4.To install a new clutch, reverse steps
Figure 23.V-BeltTension
3.A loose
4.If the