Leica ICC50 HD manual Setup Camera Camera Settings, Select to flip image

Page 35

SETUP CAMERA (Camera Settings)

COLOR

EXPOSURE

RESOLUTION

SETUP CAMERA

SETUP USER

Main menu

SET DATE TIME	PRESS OK

RESET CAMERA	PRESS OK

FLIP IMAGE	0°

OVERLAY	NONE

CAM MODE	PC-MODE

Submenu

RESET CAMERA

This command resets the camera to the factory settings. All user informa- tion (such as white balance, resolution etc.) is reset.

FLIP IMAGE

Select to flip image 180°.

OVERLAY

Shows the following on the monitor: Leica logo, histogram, date/time and image counter.

The camera settings enable you to control internal parameters such as the date or time, update the firmware or reset the camera. You can

also switch the camera from stand-alone to PC mode (or vice versa).

SET DATE TIME

This command sets the date and time as well as the format for display- ing them. The following formats are available for selection: YYMMDD –

DDMMYY – MMDDYY

CAMERA MODE

Toggles between the PC and HD modes. You can also toggle between PC and HD mode by pressing the black button for more than 5 sec until a message appears on the screen.

Leica ICC50 HD	Manual	35

Image 35

Contents Leica ICC50 HD Manual Contents General Instructions Safety concept Provide clarity Symbols usedImportant information Non-intended use Safety regulationsDescription Designated useTransport EC Declaration of Conformity DisposalLegal regulations Leica ICC50 HD Leica Application Suite IntroductionReal Full HD display High Definition HD Mode For use without a computerPower BasicsPC Mode For use with Leica Imaging Software SD card Slot Accepts SD card for stand- alone image capture Leica ICC50 HD OverviewBlack Multipurpose Button Second page through illuminationFront Need arise UnpackingGet Ready Preparation for Use Preparation for UseTools used ϘϘ Allen key Microscope’s viewing tubePreparation for Use Get Set Your computer Connection and Operation for Imaging using a ComputerInstalling and Connecting With the ICC50 HDAspect ratio Limitations in PC ModeRemote control Computer using Leica Application SuiteHdmi interface Using an Additional Hdmi Monitor in PC ModeConnecting the Hdmi monitor Capturing Images without a computer Only switches to PC mode when the Leica software is startedCamera into the power-jack in the back Power outletCapturing an image How to handle SD memory cards Using High Definition Video without a computer Factory settings Setting a new white balance for the ICC50 HDTion is available when you reset the camera Setting a new white balanceCamera Menu Remote control does not work if the camera is in PC mode Optional remote controlViewing images and movies with the optional remote control Opening and closing the camera menu Software and re-power up the cameraPoint the remote control towards the camera Calling up the Camera MenuEnabling automatic white balance Color Automatic White BalanceColor Manual White Balance Adjusting the white balance manually recommendedAutomatic exposure Manual exposureQuality of the image capture Live resolution of the live imageCaptured resolution of the captured image Movie resolution of videosSelect to flip image Setup Camera Camera SettingsSelect the language of the menu Setup User User-defined SettingsSET Illum -1 to 3 save illumination modes Defines how long the menu is displayed on the screenAppears Changing the illumination modePredefined Illumination Scenarios Wide spectrum of possible situationsLeica ICC50 HD Manual Ready! Set! Go Care and Cleaning Electrical Considerations Care and CleaningGeneral Specifications Order numbers Leica ICC50 HD camera moduleOther Mechanical and optical interfacesElectronic interfaces