Caller ID Speaker Phone w/SOS Remote Control V11M11_IM_EN_04222008
OPERATIONAL INSTRUCTIONS
Receiving a call Using the Pendant Remote
Telephone will ring to alert the user of an incoming call.
1.When there is an incoming call, pick up the handset or press [SPEAKER] to receive the call.
2.You may also use pendant remote to pick up the call. When there is an incoming call, just press the button of the pendant remote and the telephone will be put in speakerphone operation.
3.After finishing the conversation, press and hold the button of the pendant remote again for a few seconds to terminate the call and the telephone will be returned to
Reviewing the Caller ID List
Press [▲] or [▼] to review incoming calls (up to 60 calls).
Erasing Data from the Caller ID List
1.Press [▲] or [▼] to find the number you wish to erase.
2.Press [DEL] to erase the number from the list.
3.Press [DEL] for approximately 3 seconds for the LCD to show “ERASE ALL?”
4.Press [DEL] again to erase the entire caller ID list.
Calling a Number from the Caller ID List
In
1.Press [▲] or [▼] to select the desired caller ID record.
2.If the record is less than 10 digits, press [OK/DIAL] once, pick up the handset and the displaying number will be dialed out automatically.
3.If the record is 10 digits and the first 3 digits of the record is the same as set area code, press [OK/DIAL], the three digits area code will be erased and it will display 7 digits number only. The LCD will display “PICK UP OR ADJ”.
Press [OK/DIAL] again to return back to 10 digits with adding area code. Press [OK/DIAL] once again to show 11 digits with adding ‘1’ as the first digits and area code as well. Pick up the phone and the number will be dialed out automatically.
- 18 - | www.jWIN.com |