Caller ID Speaker Phone w/SOS Remote Control V11M11_IM_EN_04222008
TROUBLESHOOTING & SPECIFICATIONS
Troubleshooting
•No Display on LCD Screen
o Brightness on display may be turned down.
Increase brightness level.
oNo batteries or batteries are improperly installed.
If no batteries, install 2 AA batteries as directed or
Install optional AC Adapter (not included).
Make sure batteries observe to polarities
•No Dial Tone when handset is picked up
oPhone may not be connected properly.
Make sure the handset jack is connected to the base jack using the colied wire.
Make sure the base jack
oTelephone service may be interrupted by the telephone company
Contact your telephone company to check the status of your service.
•Static or interruptions during phone conversation
oBad connection between phones
Hang up and dial number again.
oHarsh weather conditions and/or lightning
Hang up and dial number when weather conditions improve.
•Can only receive incoming calls and cannot make outgoing calls
oTelephone service may be limited or suspended by your telephone company
Contact your telephone company to check the status of your service.
Important Note:
To operate this unit, you must have “CALLER ID SERVICE” setup with your local telephone company. Some functions such as CALLER NAME INDICATION will only operate if such service is included in the user’s Caller I.D. program with the local telephone company.
Specifications
•Power Requirement
oBattery: 6V (4 x “AA” batteries, not included)
oAC Adapter: DC 9V, 300mA, center negative (AC adapter not included)
•Unit Weight: Approx. 1.4 lbs (0.640kg)
- 22 - | www.jWIN.com |