TROUBLE SHOOTING
PROBLEMS | CHECK | |
| Is any plug disconnected from the modular | |
No dial tone | phone plug? Is any jack improperly wired? | |
| Use another phone to test the jack. | |
Phone does not | Are all cords connected properly? Are all 3 | |
“AA” batteries installed? Make sure they are | ||
work | ||
installed according to the polarity shown. | ||
| ||
Phone does not | RINGER switch may be set to OFF? Slide | |
ring | switch to HI or LOW position. | |
| Check the TONE/PULSE setting. You may | |
Can not dial | only have PULSE service. Set the TONE/ | |
| PULSE to PULSE mode (see page 7). | |
|
| |
Display shows | You have selected the wrong languages. | |
erroneous figure | Refer to page 7 and reset the language. It | |
OR No dial tone | may be helpful to remove the batteries and | |
or Low dial tone | the line cord for 30 seconds first. | |
or cannot dial out |
| |
Cannot store into | No batteries are installed or batteries are | |
memory | weak or installed | |
Caller ID does | Make sure the Caller ID service is active. | |
- The phone is connected to a working wall jack. | ||
not work | - All line cord connections are correct and secure. | |
| ||
|
| |
The display gets | Check if batteries are properly installed, and | |
if you have received the first Caller ID record. | ||
dim or is blank | If you have, your batteries may be weak. | |
| Replace all the batteries. | |
| The Caller ID unit will not function until you | |
| have subscribed to Caller ID service from | |
| your local telephone company. Call your | |
The Caller ID | local telephone company to have Caller ID | |
service installed on your phone line. Also, | ||
display does not | fresh batteries must be installed. | |
show the caller’s | Make sure all your phone line connections | |
information | are secure and correct. | |
| If it is a private call or a blocked call, the | |
| caller’s name and/or phone number will not | |
| appear on the display. (You will see time | |
| and date of call plus some dashes or the | |
| words “PRIVATE CALL” or “UNAVAILABLE” .) | |
|
| |
Static noise on | Make sure the COILED HANDSET CORD is | |
line, cannot hear | connected properly. OR Replace the COILED | |
calling party or | HANDSET CORD. Any phone store has these | |
calling party can | cords in different lengths. After some time the | |
not hear you | cord may become overstretched or damaged. | |
| Check if “ ” shows in the display. Since | |
Redial does not | the REDIAL/PAUSE button has combined | |
function (pause), the phone may have been | ||
work | paused. Just press the HOOK switch or | |
| FLASH button to get a new dial tone. |
14