Grandstream Networks DP710 manual Acs Url

Authenticate Conf File	If set to Yes, config file is authenticated before acceptance. This protects the
	configuration from an unauthorized change.
Firmware Key	Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
	user should keep it blank.
SSL Certificate	The user specifies SSL certificate used for SIP over TLS in X.509 format.
SSL Private Key	The user specifies SSL private key used for SIP over TLS in X.509 format.
SSL Private Key	The user specifies password to protect the private key above.
Password
ACS URL	The user specifies the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username	The user specifies the ACS Username
ACS Password	The user specifies the ACS password
Periodic Inform	Default is No. If set to YES, device will send inform packets to the ACS
Enable
Periodic Inform	Frequency that the inform packets will be sent out to the ACS
Interval
Connection Request	Set a user name for the ACS to connect to this device
Username
Connection Request	Set a password for the ACS to connect to this device
Password
CPE SSL Certificate	The user specifies SSL certificate used to connect to the ACS server via HTTPS in X.509
	format.
CPE SSL Private Key	The user specifies SSL private key used to connect to the ACS server via HTTPS in
	X.509 format.
Call Progress Tones	Using these settings, users can configure tone frequencies and cadence according to
	their preference. By default they are set to North American frequencies. Configure these
	settings with known values to avoid uncomfortable high pitch sounds. ON is the period of
	ringing (“On time” in ‘ms’) while OFF is the period of silence. In order to set a continuous
	tone, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then
	repeat the pattern.
	Example configuration for N.A. Dialtone:
	f1=350@-13,f2=440@-13,c=0/0;
	Syntax: f1=freq@vol, f2=freq@vol, c=on1/off1-on2/off2-on3/off3; [...]
	(Note: freq: 0 - 4000Hz; vol: -30 - 0dBm)
Lock Keypad Update	Default is No.If set to “Yes”, the configuration update via keypad is disabled.
Disable Voice Prompt	Default is No. Disables the voice prompt configuration.
Disable Direct IP Call	Default is No. Disables the Direct IP Call function.
NTP server	URI or IP address of the NTP (Network Time Protocol) server. This parameter
	synchronizes the date and time.
Allow DHCP option 42	Default No. Enables the DHCP server to handle the NTP Server via Option 42
to override NTP server

Firmware version 1.0.0.23 DP715/DP710 User Manual Page 40 of 52