Remote Access
Remote access
Remote access authorisation code
Your answering system has 3 digit personal access authorisation (Remote Code) so that only you can listen to incoming messages using the remote access facility. The authorisation code can be found on a label located on the underside of your unit.
Toll Saver
If you choose the Toll Saver option, and there are new messages, the system answers after two rings. Otherwise, the system answers after six rings. This lets you avoid unnecessary charges when calling to check your messages. If you hear more than two rings, you can hang up as the system has no new messages.
Set the slide control to the “TS” position. If you now call your system when you are away, the answering system answers as follows:
A. If your call is answered after 2 rings, there are new messages on your answering system and you can continue as described under Remote access facilities
B. If no new messages have been recorded, your call will not be answered after 2 rings. Hang up after the third ring. In this way, you can save the call charge.
Remote access facilities
Call your own telephone number and allow the greeting message to play through to the end. Wait until your answering system is ready to record a message. After the tone, enter your personal authorisation code by pressing the appropriate numbers on the phone.
Two tones confirm that the right code has been entered. Now select one of the functions listed below by pressing the appropriate combination of keys. The pause between entering the individual functions must
not exceed 20 seconds as, otherwise, the connection will be cut off automatically.
13